Уязвимости linux · Страница 60

ext4: validate readdir offset before accessing dirent

In the Linux kernel, the following vulnerability has been resolved: ext4: validate readdir offset before accessing dirent A corrupted directory can trigger the following KASAN report when ext4_readdir() resumes from an invalid position: BUG: KASAN: use-after-free in __ext4_check_dir_entry+0x5ef/0x820 Read of size 2 at addr ffff88810a646000 by task repro_linear/509 Call Trace: <TASK> dump_stack_lvl+0x53/0x70 print_report+0xd0/0x630 kasan_report+0xce/0x100 __ext4_check_dir_entry+0x5ef/0x820 ext4_readdir+0xcde/0x2b70 iterate_dir+0x1a1/0x520 __x64_sys_getdents64+0x12b/0x220 do_syscall_64+0xf9/0x540 entry_SY

wifi: ath6kl: avoid buffer overreads in WMI event handlers

In the Linux kernel, the following vulnerability has been resolved: wifi: ath6kl: avoid buffer overreads in WMI event handlers The following WMI event handlers currently read from the event buffer without first verifying that the message was large enough to hold the expected event: ath6kl_wmi_scan_complete_rx() ath6kl_wmi_addba_req_event_rx() ath6kl_wmi_delba_req_event_rx() Add length checks to prevent overread.

• Обновитесь до 6.1.190-1

wifi: ath11k: Avoid buffer overread in ath11k_wmi_tlv_op_rx()

In the Linux kernel, the following vulnerability has been resolved: wifi: ath11k: Avoid buffer overread in ath11k_wmi_tlv_op_rx() Currently, in ath11k_wmi_tlv_op_rx(), the firmware buffer is read without first verifying that the buffer has enough data to hold a header. This could result in a buffer overread. Add an upfront length check before dereferencing skb->data as a wmi_cmd_hdr. The check is placed before the trace_ath11k_wmi_event() call to preserve the existing trace semantics (tracing the full raw WMI event including the header), unlike the analogous ath12k fix which could use skb_pull_data() directly. Compile tested only.

• Обновитесь до 6.1.190-1

ext4: fix buffer_head leak in ext4_init_orphan_info

In the Linux kernel, the following vulnerability has been resolved: ext4: fix buffer_head leak in ext4_init_orphan_info ext4_init_orphan_info() reads orphan file blocks with ext4_bread() and stores the returned buffer_head in oi->of_binfo[i].ob_bh. If ext4_bread() succeeds but the orphan block magic or checksum validation fails, the function jumps to out_free. However, the old out_free loop starts releasing buffers from i - 1, so the current buffer_head at index i is skipped. This leaks the buffer_head reference obtained by ext4_bread() on the bad magic and bad checksum error paths. Fix this by tracking the number of successfully read bu

• Обновитесь до 6.1.190-1

cpufreq: amd-pstate-ut: Skip tests when amd-pstate driver is not active

In the Linux kernel, the following vulnerability has been resolved: cpufreq: amd-pstate-ut: Skip tests when amd-pstate driver is not active The crash issue may occur when modprobe amd_pstate_ut on intel platform. amd_pstate_ut: 1 amd_pstate_ut_acpi_cpc_valid success! amd_pstate_ut: 2 amd_pstate_ut_check_enabled success! BUG: kernel NULL pointer dereference, address: 0000000000000080 #PF: supervisor read access in kernel mode #PF: error_code(0x0000) - not-present page PGD 0 P4D 0 Oops: 0000 [#1] SMP NOPTI CPU: 0 PID: 20300 Comm: modprobe Kdump: loaded Tainted: G O 6.6.0-0010.rc1.ctl4.x86_64 #1 Hardware

RDMA/erdma: complete object teardown when the destroy command fails

In the Linux kernel, the following vulnerability has been resolved: RDMA/erdma: complete object teardown when the destroy command fails erdma_destroy_qp(), erdma_destroy_cq(), erdma_dereg_mr(), and erdma_destroy_ah() returned early when erdma_post_cmd_wait() failed, leaking the queue buffers, MTTs, doorbells and the STAG, QPN, CQN and AHN identifiers. A command timeout clears ERDMA_CMDQ_STATE_OK_BIT and permanently disables the command queue, so no retry can succeed; the RDMA core keeps the object after a failed destructor and forced uverbs cleanup then nulls the pointers, making the resources unreachable. Warn on failure but release every

bpf: Fix WARNING in bpf_tracing_link_release

In the Linux kernel, the following vulnerability has been resolved: bpf: Fix WARNING in bpf_tracing_link_release The trampoline could be corrupted by the blindly 'tr->flags = BPF_TRAMP_F_TAIL_CALL_CTX' in verifier. 1. A fexit attached to a tail_call_reachable prog. 'tr->flags' became 'BPF_TRAMP_F_CALL_ORIG | BPF_TRAMP_F_TAIL_CALL_CTX'. And, the trampoline would poke the target prog's nop insn using jmp insn instead of call insn. 2. Another fexit loaded with the same tail_call_reachable prog target. 'tr->flags' became 'BPF_TRAMP_F_TAIL_CALL_CTX'. 3. Close the first fexit link. Due to no BPF_TRAMP_F_CALL_ORIG in 'tr->flags', t

pinctrl: mediatek: use devm_gpiochip_add_data() for GPIO chip

In the Linux kernel, the following vulnerability has been resolved: pinctrl: mediatek: use devm_gpiochip_add_data() for GPIO chip The gpio_chip is allocated with device-managed memory but registered with the non-managed gpiochip_add_data(). This was harmless while the drivers were built-in, but once they can be built as modules and unbound/rmmod'd, devm frees the gpio_chip's memory while it is still registered, causing a use-after-free. Register it with devm_gpiochip_add_data() so it shares the same device-managed lifecycle, which also lets the manual gpiochip_remove() error paths go away.

pinctrl: mediatek: free EINT resources on unbind

In the Linux kernel, the following vulnerability has been resolved: pinctrl: mediatek: free EINT resources on unbind mtk_eint_do_init() creates an IRQ domain, populates it with a mapping for every EINT line and installs a chained handler on the parent interrupt, but none of these are ever released. This was harmless while the drivers were built-in, but now that they can be built as modules and unbound/rmmod'd it leaves behind a dangling IRQ domain, interrupt mappings whose chip data points at freed memory, and a chained handler that keeps firing into that freed data. The plain allocations in mtk_eint_do_init() already use the device-manage

• Обновитесь до 6.1.190-1

scsi: ufs: core: Validate string descriptors

In the Linux kernel, the following vulnerability has been resolved: scsi: ufs: core: Validate string descriptors The string descriptor length includes a two-byte header while the UTF-16 payload starts after it. utf16s_to_utf8s() expects a count of UTF-16 code units, not bytes. Passing the payload byte count can make it read beyond the descriptor buffer. Validate that the payload has an even byte count, pass a code-unit count to the converter, and allocate sufficient UTF-8 output space. The raw string buffer starts after the descriptor header but its size is bLength. Copying bLength bytes from that pointer can read beyond the response buff

scsi: ufs: debugfs: Reserve space for a string terminator

In the Linux kernel, the following vulnerability has been resolved: scsi: ufs: debugfs: Reserve space for a string terminator ufs_saved_err_write() copies user input into a zero-initialized stack buffer and passes it to kstrtoint(). A write that fills the entire buffer overwrites its only terminator. Reject an input whose length leaves no room for the trailing NUL.

• Обновитесь до 6.1.190-1

crypto: keembay - Initialize completion before requesting IRQ

In the Linux kernel, the following vulnerability has been resolved: crypto: keembay - Initialize completion before requesting IRQ kmb_ocs_aes_probe() requests the device IRQ before initializing irq_completion. Once the handler is registered it can run immediately, and ocs_aes_irq_handler() unconditionally calls complete(). An interrupt in this window would therefore use an uninitialized completion. Initialize the completion before requesting the IRQ, as the sibling OCS HCU and ECC drivers already do.

• Обновитесь до 6.1.190-1

RDMA/mlx5: Fix integer overflow of user QP buffer size

In the Linux kernel, the following vulnerability has been resolved: RDMA/mlx5: Fix integer overflow of user QP buffer size set_user_buf_size() computes the QP buffer size by left-shifting the user-supplied rq.wqe_cnt and rq.wqe_shift values as signed integers. A sufficiently large rq.wqe_cnt causes signed integer overflow, which is undefined behavior, and yields a small or negative buf_size, causing ib_umem_get() to map a buffer smaller than the hardware will actually write into. Replace the shifts and addition with check_shl_overflow() and check_add_overflow(), rejecting invalid user inputs. Moreover, guard the identical shift computing

• Обновитесь до 6.1.190-1

isofs: release zisofs block pointer buffer head

In the Linux kernel, the following vulnerability has been resolved: isofs: release zisofs block pointer buffer head zisofs_fill_pages() reads the compressed block pointer table. The error paths release the current buffer_head, the loop also releases the old buffer_head when it advances. However, the success path leaves the last buffer_head referenced. Release it before returning success.

• Обновитесь до 6.1.190-1

spi: oc-tiny: switch to managed controller allocation

In the Linux kernel, the following vulnerability has been resolved: spi: oc-tiny: switch to managed controller allocation The controller is allocated with the non-managed spi_alloc_host() while the interrupt is registered with devm_request_irq(). During removal, spi_bitbang_stop() only unregisters the controller; the subsequent spi_controller_put() then frees the controller together with its embedded driver-private devdata, which is the IRQ handler's dev_id. The devm_request_irq() release action (free_irq()), which drains the handler, does not run until after .remove() returns. A late or latched interrupt can therefore reach tiny_spi_irq

remoteproc: Prevent crash handling to race with rproc_del()

In the Linux kernel, the following vulnerability has been resolved: remoteproc: Prevent crash handling to race with rproc_del() There's no synchronization between rproc_crash_handler_work() and rproc_del(), as such it's possible for a driver to be removed while crash-handler work is scheduled, or even executing - resulting in use-after-free issues. To avoid this the scheduled work need to be cancelled and synchronized against before the removal proceeds. In order to ensure that this doesn't race with the reporting, and thereby scheduling new work, a "deleting" flag is introduced. This is similar to the RPROC_DELETE state that was introduc

• Обновитесь до 6.1.190-1

PCI: Fix UAF when probe runs concurrent to dyn ID removal

In the Linux kernel, the following vulnerability has been resolved: PCI: Fix UAF when probe runs concurrent to dyn ID removal Dynamic IDs are only guaranteed to be valid when dynids.lock is held, as remove_id_store() can free the node. Thus, make a copy in pci_match_device(). Also, clarify that the id parameter is only valid during probe.

nilfs2: fix infinite loop in nilfs_clean_segments()

In the Linux kernel, the following vulnerability has been resolved: nilfs2: fix infinite loop in nilfs_clean_segments() syzbot reported a hung task in nilfs_transaction_begin(). This occurs because the cleaner ioctl falls into an infinite loop if nilfs_segctor_construct() repeatedly returns -EROFS (e.g. the device is remounted as read-only after an I/O error). Currently in nilfs_clean_segments(), if err is non-zero, it logs the error and sleeps but doesn't abort when it encounters a terminal error like -EROFS. This causes the thread to loop forever. Fix this by breaking out of the loop if nilfs_segctor_construct() returns -EROFS. This mat

• Обновитесь до 6.1.190-1

nilfs2: prevent out-of-bounds read in super root block parsing

In the Linux kernel, the following vulnerability has been resolved: nilfs2: prevent out-of-bounds read in super root block parsing super-root inode metadata size is trusted before nilfs_read_inode_common(). Reject super-root inode sizes whose computed on-disk footprint exceeds the filesystem block size. This prevents malformed filesystem images from making nilfs_read_inode_common() read past the end of the super-root block. [ryusuke: clarify the commit title]

• Обновитесь до 6.1.190-1

nilfs2: fix BUG in nilfs_copy_dirty_pages() on dirty state mismatch

In the Linux kernel, the following vulnerability has been resolved: nilfs2: fix BUG in nilfs_copy_dirty_pages() on dirty state mismatch Syzbot reported a kernel BUG triggered within nilfs_copy_dirty_pages(), which copies dirty DAT file folios/pages to its shadow page cache. The BUG occurs when a retrieved dirty folio/page unexpectedly loses its 'dirty' status. This issue arises because, since the commit referenced below, the 'dirty' flag of a folio/page can be cleared asynchronously after the filesystem detects metadata corruption and transitions to read-only mode. Resolve the issue by returning an -EROFS error if the filesystem has tran