Уязвимости linux · Страница 12

isofs: handle set_blocksize failures

In the Linux kernel, the following vulnerability has been resolved: isofs: handle set_blocksize failures isofs uses buffer_heads, which don't handle block size > PAGE_SIZE well. Without this, mounting we will hit the BUG_ON(offset >= folio_size(folio)); in folio_set_bh on the first __bread_gfp call.

• Обновитесь до 7.2.6-1

irqchip/gic-v5: Immediately exec priority drop following activate

In the Linux kernel, the following vulnerability has been resolved: irqchip/gic-v5: Immediately exec priority drop following activate With GICv5 an interrupt of equal or lower priority cannot be signalled until there has been a priority drop. This is done via the GIC CDEOI system instruction. Once this has been executed, the hardware is able to signal the next interrupt if there is one. As all interrupts are programmed to have the same priority, no new interrupts can be signalled until the priority drop has happened. This can cause issues when, for example, an interrupt remains active while a long running process takes place, such as when

• Обновитесь до 7.2.6-1

irqchip/gic-v4: Don't advertise VLPIs if no ITS is probed

In the Linux kernel, the following vulnerability has been resolved: irqchip/gic-v4: Don't advertise VLPIs if no ITS is probed When accidentally setting “kvm-arm.vgic_v4_enable=1” on a system that has no MSI controller device tree node and GICv4, it results a panic as “gic_domain” is NULL and the kernel attempts to access it. Unable to handle kernel NULL pointer dereference at virtual address 0000000000000028 Mem abort info: ESR = 0x0000000096000006 CPU: 1 UID: 0 PID: 295 Comm: lkvm-static Not tainted 7.1.0-rc4-ge3f15ad3970e #5 PREEMPT Hardware name: linux,dummy-virt (DT) pstate: 81402005 (Nzcv daif +PAN -UAO -TCO

• Обновитесь до 7.2.6-1

host1x: bus: Fix missing ops null check in error teardown

In the Linux kernel, the following vulnerability has been resolved: host1x: bus: Fix missing ops null check in error teardown In host1x_device_init(), the error teardown paths do not check client->ops before dereferencing it, unlike the forward init paths which correctly guard with 'client->ops &&'. This can result in a NULL pointer dereference if client->ops is NULL. Fix by adding the missing client->ops check in both the teardown and teardown_late labels.

• Обновитесь до 7.2.6-1

drm/nouveau/gsp: add SEC2 to GA100 chip table

In the Linux kernel, the following vulnerability has been resolved: drm/nouveau/gsp: add SEC2 to GA100 chip table The booter-load and booter-unload firmware run on the SEC2 falcon. During tu102_gsp_oneinit(), the booter constructor needs device->sec2 to access the SEC2 falcon. Without the .sec2 entry, device->sec2 is NULL and this dereference crashes during GSP-RM boot.

• Обновитесь до 7.2.6-1

wifi: iwlwifi: mld: don't WARN on WoWLAN suspend w/o netdetect

In the Linux kernel, the following vulnerability has been resolved: wifi: iwlwifi: mld: don't WARN on WoWLAN suspend w/o netdetect Clearly, from a user perspective, it must be valid to configure WoWLAN and then suspend while not connected to a network. Since mac80211 doesn't distinguish these cases and simply calls the driver to suspend whenever WoWLAN is configured, the driver has to cleanly handle the case where it's called for WoWLAN, it's not connected but there's also no netdetect configured. Remove the WARN_ON() and keep returning 1 to disconnect and then suspend.

• Обновитесь до 7.2.6-1

netfilter: nf_conntrack_expect: zero at allocation time

In the Linux kernel, the following vulnerability has been resolved: netfilter: nf_conntrack_expect: zero at allocation time There are occasional LLM hints wrt. leaking uninitialized data to userspace via ctnetlink. Just zero at allocation time, expectations are not frequently used these days. Intentionally keeps _init as-is because we could theoretically support re-init, so add the missing exp->dir there.

• Обновитесь до 7.2.6-1

freevxfs: don't BUG() on unknown typed-extent type

In the Linux kernel, the following vulnerability has been resolved: freevxfs: don't BUG() on unknown typed-extent type vxfs_bmap_typed() handles four typed-extent types and calls BUG() in its default case, so an on-disk typed extent with any other type value crashes the kernel. It is reachable from ioctl(FIBMAP) on a regular file: kernel BUG at fs/freevxfs/vxfs_bmap.c:230! RIP: vxfs_bmap_typed fs/freevxfs/vxfs_bmap.c:230 [inline] vxfs_bmap1+0x128a/0x12d0 fs/freevxfs/vxfs_bmap.c:257 Replace the BUG() with WARN_ON_ONCE() and return 0 -- the value vxfs_bmap_typed() already returns on failure (and from the DEV4 case above); vxfs_ge

• Обновитесь до 7.2.6-1

crypto: ccp - Fix possible deadlock in SEV init failure path

In the Linux kernel, the following vulnerability has been resolved: crypto: ccp - Fix possible deadlock in SEV init failure path __sev_platform_init_handle_init_ex_path() calls rmp_mark_pages_firmware() with locked=false while the parent function of init_ex_path already acquired the sev_cmd_mutex. In the case of an RMPUPDATE failure for any page after the first, the cleanup path would invoke reclaim pages which would result in a deadlock in sev_do_cmd. Pass locked=true to honor the lock status of the parent function.

• Обновитесь до 7.2.6-1

Bluetooth: ISO: Copy BASE if service data matches EIR_BAA_SERVICE_UUID

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: ISO: Copy BASE if service data matches EIR_BAA_SERVICE_UUID Copy the content of a Periodic Advertisement Report to BASE only if the service UUID is Basic Audio Announcement Service UUID.

• Обновитесь до 6.7.7-1

bpf: Infer zext_dst based on static register liveness analysis

In the Linux kernel, the following vulnerability has been resolved: bpf: Infer zext_dst based on static register liveness analysis As reported in the thread [1], the verifier's 32-bit operations zero extension logic is broken. This logic is responsible for correct semantics of 32-bit operations on s390 architecture. According to BPF semantics, operation `w1 += 1` is supposed to zero extend the upper half of the register `r1`. On s390 the JIT relies on the verifier emitting explicit zero extension before such operations. The verifier attempts to minimize the amount of zero extensions inserted by tracking whether upper halves of the 64-bit

dm-pcache: reject a kset that overruns its segment

In the Linux kernel, the following vulnerability has been resolved: dm-pcache: reject a kset that overruns its segment cache_replay(), the writeback worker and the GC worker read a kset of get_kset_onmedia_size() bytes and advance the position by it. A forged key_num makes that size exceed the segment's remaining space, so the advance walks past the segment and trips the cache_pos_advance() BUG_ON. Reject a kset whose on-media size exceeds cache_seg_remain() before use.

• Обновитесь до 7.2.10-1

dm-pcache: bound the logical key offset from persistent memory

In the Linux kernel, the following vulnerability has been resolved: dm-pcache: bound the logical key offset from persistent memory cache_key_decode() takes a key's logical off from the cache device and later indexes req_key_tree->subtrees[] by it in get_subtree(). An off past the device forms a subtree pointer outside the array, which rb_insert() writes through during replay. Reject a key of zero length, or whose off+len (computed in 64 bits) exceeds the device size, before it is used.

• Обновитесь до 7.2.10-1

sched/cache: Introduce task_struct->sched_cache_grp to fix UAF

In the Linux kernel, the following vulnerability has been resolved: sched/cache: Introduce task_struct->sched_cache_grp to fix UAF Add a sched_cache_grp pointer to task_struct so that scheduler code can access the cache group directly via the task, without going through mm->sched_cache_grp. This decouples the scheduler's hot-path accesses from the mm_struct. Each task holds its own refcount on the sched_cache_group, separate from the reference held by its mm_struct. The reference is acquired in copy_mm() (fork) and exec_mmap() (exec), and released in exit_mm(). This fixes the use-after-free when account_mm_sched() reaches the group throu

• Обновитесь до 7.2.10-1

sched_ext: Don't run ops.dequeue() with a DSQ lock held

In the Linux kernel, the following vulnerability has been resolved: sched_ext: Don't run ops.dequeue() with a DSQ lock held ops.dequeue() is invoked with the source user DSQ's lock still held on the consume and move paths (scx_consume_dispatch_q(), move_task_between_dsqs()). A BPF scheduler which locks the source user DSQ from ops.dequeue() - e.g. by iterating it with bpf_iter_scx_dsq - self-deadlocks. ops.dequeue() can only call the "any" kfuncs and none of them can lock a builtin DSQ, so the global and bypass paths can't deadlock; however, all DSQ locks share one lockdep class, so iterating any user DSQ from ops.dequeue() on those paths

• Обновитесь до 7.2.10-1

sched_ext: Wait for SCX_OPSS_DISPATCHING before reenqueueing a task

In the Linux kernel, the following vulnerability has been resolved: sched_ext: Wait for SCX_OPSS_DISPATCHING before reenqueueing a task ebf1ccff79c4 ("sched_ext: Fix ops.dequeue() semantics") moved the final ops_state store in scx_dispatch_enqueue() after the DSQ unlock so that the custody update and ops.dequeue() precede it. A task can thus be found on a DSQ while still SCX_OPSS_DISPATCHING. The dequeue and core-sched pick paths wait for the state to clear in ops_dequeue() but the reenqueue paths don't. A reenqueue in that window runs ops.enqueue() and sets SCX_OPSS_QUEUED before the dispatch has completed. The dispatcher's final store th

• Обновитесь до 7.2.10-1

KVM: x86: Re-pend GET_NESTED_STATE_PAGES if getting said pages fails

In the Linux kernel, the following vulnerability has been resolved: KVM: x86: Re-pend GET_NESTED_STATE_PAGES if getting said pages fails Re-pend GET_NESTED_STATE_PAGES before exiting to userspace if getting the nested pages fails in the KVM_RUN path. If userspace re-runs the vCPU, and vmcs02 holds valid PFNs from the *previous* run of L2, then KVM could re-enter L2 with stale, unpinned PFNs mapped into e.g. the vAPIC page. Note, both SVM and VMX (as of commit 11722439fb20 ("KVM: nVMX: Ensure KVM_REQ_GET_NESTED_STATE_PAGES is cleared on VM-Exit") ensure the request is cleared on VM-Exit (including the "forced" case), i.e. there is no risk

• Обновитесь до 7.2.10-1

audit: fix exe mark UAF in kill_rules()

In the Linux kernel, the following vulnerability has been resolved: audit: fix exe mark UAF in kill_rules() kill_rules() removes mixed AUDIT_DIR and AUDIT_EXE rules when an audit tree is pruned. It drops entry->rule.exe before removing the rule from the RCU-visible filter lists. After a rule has been installed with AUDIT_ADD_RULE, which requires CAP_AUDIT_CONTROL, removing the watched directory can race with another task that is still evaluating the rule. In that case, fsnotify can free the executable mark before the reader reaches audit_mark_compare(), causing a use-after-free. KASAN reports: BUG: KASAN: slab-use-after-free in audit

• Обновитесь до 7.2.10-1

fprobe: Use guard(rcu_sched_notrace) and check rcu_is_watching()

In the Linux kernel, the following vulnerability has been resolved: fprobe: Use guard(rcu_sched_notrace) and check rcu_is_watching() unregister_fprobe() and unregister_fprobe_async() (used by BPF kprobe-multi) rely on standard RCU grace periods (synchronize_rcu() and call_rcu()) to wait until in-flight fprobe handlers complete before freeing the fprobe. However, if an fprobe handler executes while RCU is not watching (such as in the idle loop or nohz_full extended quiescent states), standard RCU does not track preemption-disabled sections. Consequently, synchronize_rcu() does not wait for those executions, which can lead to a use-after-fre

• Обновитесь до 7.2.10-1

HID: bpf: cast size to ssize_t when checking hid_bpf_hw_request

In the Linux kernel, the following vulnerability has been resolved: HID: bpf: cast size to ssize_t when checking hid_bpf_hw_request As reported by Sashiko: If a transport driver encounters a hardware error and returns a negative error code such as -EPIPE, ret is implicitly promoted to size_t when compared against size. This causes the negative error code to evaluate as a large positive number, making the (ret > size) condition true. This silently converts the hardware error into a success return value and copies the unmodified buffer back, which could leave BPF programs operating on uninitialized or stale data. Fix this by casting size in

• Обновитесь до 7.2.10-1