In the Linux kernel, the following vulnerability has been resolved:
MIPS: Octeon: Add PCIe link status check
The standard PCIe configuration read-write interface is used to
access the configuration space of the peripheral PCIe devices
of the mips processor after the PCIe link surprise down, it can
generate kernel panic caused by "Data bus error". So it is
necessary to add PCIe link status check for system protection.
When the PCIe link is down or in training, assigning a value
of 0 to the configuration address can prevent read-write behavior
to the configuration space of peripheral PCIe devices, thereby
preventing kernel panic.
serial: imx: Introduce timeout when waiting on transmitter empty
In the Linux kernel, the following vulnerability has been resolved:
serial: imx: Introduce timeout when waiting on transmitter empty
By waiting at most 1 second for USR2_TXDC to be set, we avoid a potential
deadlock.
In case of the timeout, there is not much we can do, so we simply ignore
the transmitter state and optimistically try to continue.
i2c: lpi2c: Avoid calling clk_get_rate during transfer
In the Linux kernel, the following vulnerability has been resolved:
i2c: lpi2c: Avoid calling clk_get_rate during transfer
Instead of repeatedly calling clk_get_rate for each transfer, lock
the clock rate and cache the value.
A deadlock has been observed while adding tlv320aic32x4 audio codec to
the system. When this clock provider adds its clock, the clk mutex is
locked already, it needs to access i2c, which in return needs the mutex
for clk_get_rate as well.
mips: bmips: BCM6358: make sure CBR is correctly set
In the Linux kernel, the following vulnerability has been resolved:
mips: bmips: BCM6358: make sure CBR is correctly set
It was discovered that some device have CBR address set to 0 causing
kernel panic when arch_sync_dma_for_cpu_all is called.
This was notice in situation where the system is booted from TP1 and
BMIPS_GET_CBR() returns 0 instead of a valid address and
!!(read_c0_brcm_cmt_local() & (1 << 31)); not failing.
The current check whether RAC flush should be disabled or not are not
enough hence lets check if CBR is a valid address or not.
ipv6: prevent possible NULL deref in fib6_nh_init()
In the Linux kernel, the following vulnerability has been resolved:
ipv6: prevent possible NULL deref in fib6_nh_init()
syzbot reminds us that in6_dev_get() can return NULL.
fib6_nh_init()
ip6_validate_gw( &idev )
ip6_route_check_nh( idev )
*idev = in6_dev_get(dev); // can be NULL
Oops: general protection fault, probably for non-canonical address 0xdffffc00000000bc: 0000 [#1] PREEMPT SMP KASAN PTI
KASAN: null-ptr-deref in range [0x00000000000005e0-0x00000000000005e7]
CPU: 0 PID: 11237 Comm: syz-executor.3 Not tainted 6.10.0-rc2-syzkaller-00249-gbe27b8965297 #0
Hardware name: Google Google Compute Engine/Google
ipv6: prevent possible NULL dereference in rt6_probe()
In the Linux kernel, the following vulnerability has been resolved:
ipv6: prevent possible NULL dereference in rt6_probe()
syzbot caught a NULL dereference in rt6_probe() [1]
Bail out if __in6_dev_get() returns NULL.
[1]
Oops: general protection fault, probably for non-canonical address 0xdffffc00000000cb: 0000 [#1] PREEMPT SMP KASAN PTI
KASAN: null-ptr-deref in range [0x0000000000000658-0x000000000000065f]
CPU: 1 PID: 22444 Comm: syz-executor.0 Not tainted 6.10.0-rc2-syzkaller-00383-gb8481381d4e2 #0
Hardware name: Google Google Compute Engine/Google Compute Engine, BIOS Google 04/02/2024
RIP: 0010:rt6_probe net/ipv6/route.c:656 [inline
xfrm6: check ip6_dst_idev() return value in xfrm6_get_saddr()
In the Linux kernel, the following vulnerability has been resolved:
xfrm6: check ip6_dst_idev() return value in xfrm6_get_saddr()
ip6_dst_idev() can return NULL, xfrm6_get_saddr() must act accordingly.
syzbot reported:
Oops: general protection fault, probably for non-canonical address 0xdffffc0000000000: 0000 [#1] PREEMPT SMP KASAN PTI
KASAN: null-ptr-deref in range [0x0000000000000000-0x0000000000000007]
CPU: 1 PID: 12 Comm: kworker/u8:1 Not tainted 6.10.0-rc2-syzkaller-00383-gb8481381d4e2 #0
Hardware name: Google Google Compute Engine/Google Compute Engine, BIOS Google 04/02/2024
Workqueue: wg-kex-wg1 wg_packet_handshake_send_worker
RI
In the Linux kernel, the following vulnerability has been resolved:
netns: Make get_net_ns() handle zero refcount net
Syzkaller hit a warning:
refcount_t: addition on 0; use-after-free.
WARNING: CPU: 3 PID: 7890 at lib/refcount.c:25 refcount_warn_saturate+0xdf/0x1d0
Modules linked in:
CPU: 3 PID: 7890 Comm: tun Not tainted 6.10.0-rc3-00100-gcaa4f9578aba-dirty #310
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.15.0-1 04/01/2014
RIP: 0010:refcount_warn_saturate+0xdf/0x1d0
Code: 41 49 04 31 ff 89 de e8 9f 1e cd fe 84 db 75 9c e8 76 26 cd fe c6 05 b6 41 49 04 01 90 48 c7 c7 b8 8e 25 86 e8 d2 05 b5 fe 90 <0f> 0b 90 90 e9 79 ff ff
seg6: fix parameter passing when calling NF_HOOK() in End.DX4 and End.DX6 behaviors
In the Linux kernel, the following vulnerability has been resolved:
seg6: fix parameter passing when calling NF_HOOK() in End.DX4 and End.DX6 behaviors
input_action_end_dx4() and input_action_end_dx6() are called NF_HOOK() for
PREROUTING hook, in PREROUTING hook, we should passing a valid indev,
and a NULL outdev to NF_HOOK(), otherwise may trigger a NULL pointer
dereference, as below:
[74830.647293] BUG: kernel NULL pointer dereference, address: 0000000000000090
[74830.655633] #PF: supervisor read access in kernel mode
[74830.657888] #PF: error_code(0x0000) - not-present page
[74830.659500] PGD 0 P4D 0
[74830.660450] O
dmaengine: idxd: Fix possible Use-After-Free in irq_process_work_list
In the Linux kernel, the following vulnerability has been resolved:
dmaengine: idxd: Fix possible Use-After-Free in irq_process_work_list
Use list_for_each_entry_safe() to allow iterating through the list and
deleting the entry in the iteration process. The descriptor is freed via
idxd_desc_complete() and there's a slight chance may cause issue for
the list iterator when the descriptor is reused by another thread
without it being deleted from the list.
KVM: Fix a data race on last_boosted_vcpu in kvm_vcpu_on_spin()
In the Linux kernel, the following vulnerability has been resolved:
KVM: Fix a data race on last_boosted_vcpu in kvm_vcpu_on_spin()
Use {READ,WRITE}_ONCE() to access kvm->last_boosted_vcpu to ensure the
loads and stores are atomic. In the extremely unlikely scenario the
compiler tears the stores, it's theoretically possible for KVM to attempt
to get a vCPU using an out-of-bounds index, e.g. if the write is split
into multiple 8-bit stores, and is paired with a 32-bit load on a VM with
257 vCPUs:
CPU0 CPU1
last_boosted_vcpu = 0xff;
(last_boosted_vcpu = 0x100)
iommu: Return right value in iommu_sva_bind_device()
In the Linux kernel, the following vulnerability has been resolved:
iommu: Return right value in iommu_sva_bind_device()
iommu_sva_bind_device() should return either a sva bond handle or an
ERR_PTR value in error cases. Existing drivers (idxd and uacce) only
check the return value with IS_ERR(). This could potentially lead to
a kernel NULL pointer dereference issue if the function returns NULL
instead of an error pointer.
In reality, this doesn't cause any problems because iommu_sva_bind_device()
only returns NULL when the kernel is not configured with CONFIG_IOMMU_SVA.
In this case, iommu_dev_enable_feature(dev, IOMMU_DEV_FEAT_SVA) will
r
ocfs2: fix races between hole punching and AIO+DIO
In the Linux kernel, the following vulnerability has been resolved:
ocfs2: fix races between hole punching and AIO+DIO
After commit "ocfs2: return real error code in ocfs2_dio_wr_get_block",
fstests/generic/300 become from always failed to sometimes failed:
========================================================================
[ 473.293420 ] run fstests generic/300
[ 475.296983 ] JBD2: Ignoring recovery information on journal
[ 475.302473 ] ocfs2: Mounting device (253,1) on (node local, slot 0) with ordered data mode.
[ 494.290998 ] OCFS2: ERROR (device dm-1): ocfs2_change_extent_flag: Owner 5668 has an extent at cpos 78723 which ca
wifi: mac80211: mesh: Fix leak of mesh_preq_queue objects
In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: mesh: Fix leak of mesh_preq_queue objects
The hwmp code use objects of type mesh_preq_queue, added to a list in
ieee80211_if_mesh, to keep track of mpath we need to resolve. If the mpath
gets deleted, ex mesh interface is removed, the entries in that list will
never get cleaned. Fix this by flushing all corresponding items of the
preq_queue in mesh_path_flush_pending().
This should take care of KASAN reports like this:
unreferenced object 0xffff00000668d800 (size 128):
comm "kworker/u8:4", pid 67, jiffies 4295419552 (age 1836.444s)
hex dump (first 32 b
wifi: iwlwifi: mvm: don't read past the mfuart notifcation
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mvm: don't read past the mfuart notifcation
In case the firmware sends a notification that claims it has more data
than it has, we will read past that was allocated for the notification.
Remove the print of the buffer, we won't see it by default. If needed,
we can see the content with tracing.
This was reported by KFENCE.
In the Linux kernel, the following vulnerability has been resolved:
gve: Clear napi->skb before dev_kfree_skb_any()
gve_rx_free_skb incorrectly leaves napi->skb referencing an skb after it
is freed with dev_kfree_skb_any(). This can result in a subsequent call
to napi_get_frags returning a dangling pointer.
Fix this by clearing napi->skb before the skb is freed.
HID: logitech-dj: Fix memory leak in logi_dj_recv_switch_to_dj_mode()
In the Linux kernel, the following vulnerability has been resolved:
HID: logitech-dj: Fix memory leak in logi_dj_recv_switch_to_dj_mode()
Fix a memory leak on logi_dj_recv_send_report() error path.
In the Linux kernel, the following vulnerability has been resolved:
drm/exynos/vidi: fix memory leak in .get_modes()
The duplicated EDID is never freed. Fix it.
mptcp: ensure snd_una is properly initialized on connect
In the Linux kernel, the following vulnerability has been resolved:
mptcp: ensure snd_una is properly initialized on connect
This is strictly related to commit fb7a0d334894 ("mptcp: ensure snd_nxt
is properly initialized on connect"). It turns out that syzkaller can
trigger the retransmit after fallback and before processing any other
incoming packet - so that snd_una is still left uninitialized.
Address the issue explicitly initializing snd_una together with snd_nxt
and write_seq.
wifi: iwlwifi: mvm: check n_ssids before accessing the ssids
In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mvm: check n_ssids before accessing the ssids
In some versions of cfg80211, the ssids poinet might be a valid one even
though n_ssids is 0. Accessing the pointer in this case will cuase an
out-of-bound access. Fix this by checking n_ssids first.