Уязвимости linux-aws · Страница 105

Bluetooth: mgmt: fix UAF in pair command cancellation

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: mgmt: fix UAF in pair command cancellation The pairing completion and authentication failure callbacks look up the pending MGMT_OP_PAIR_DEVICE command by walking hdev->mgmt_pending. The lookup returned a command that was still linked on the shared pending list, without keeping mgmt_pending_lock held for the later dereference and removal. A concurrent MGMT_OP_CANCEL_PAIR_DEVICE request can remove and free the same pending command before the callback uses it. The reverse race is also possible when cancel_pair_device() gets a command from pending_find() and a callb

Bluetooth: hci_sync: Fix advertising data UAFs

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: hci_sync: Fix advertising data UAFs hci_find_adv_instance() returns an adv_info pointer that is valid only while hdev->lock is held. The advertising command-sync paths perform instance lookups without that lock and, in some cases, retain the pointer while waiting for a controller response. An advertising termination event can therefore interleave as follows: hci_cmd_sync_work hci_rx_work hci_find_adv_instance() __hci_cmd_sync_status() wait for controller reply hci_dev_lock() hci_remove_adv_ins

Bluetooth: HIDP: reject frames without a transaction header

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: HIDP: reject frames without a transaction header hidp_recv_ctrl_frame() and hidp_recv_intr_frame() read skb->data[0] before checking that the L2CAP SDU contains a transaction header. A connected HIDP peer can send an empty basic-mode SDU and make both paths use an uninitialized byte from skb tailroom. KMSAN reports the use in hidp_session_run(), with the uninitialized value originating in __alloc_skb() through vhci_write(). The control path produces two reports and the interrupt path produces one. The byte can also be controlled by a malformed lower-layer packe

• Обновитесь до 5.15.0-1117.124

Bluetooth: HIDP: validate numbered report payloads

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: HIDP: validate numbered report payloads When hidp_get_raw_report() waits for a numbered report, hidp_process_data() compares the expected report number with skb->data[0]. A connected HIDP peer can reply with only a DATA transaction header, leaving the skb empty after the header is removed. KMSAN reports an uninitialized-value use in hidp_session_run(), with the value originating in __alloc_skb() through vhci_write(). The transaction header checks remove the empty-frame reports, but this report remains until the payload check is added. The comparison can also co

• Обновитесь до 5.15.0-1117.124

afs: Fix UAF when sending a message

In the Linux kernel, the following vulnerability has been resolved: afs: Fix UAF when sending a message In afs_make_call(), there's a race with async call reception and destruction. If a call is dispatched that doesn't have call->write_iter set (used to specify the data content for FS.StoreData), then the first rxrpc_kernel_send_data() will not set MSG_MORE in the msghdr. Once rxrpc_send_data() queues the last request packet, the response could come in at any time and cause the call to be completed and put. However, afs_make_call() will look at the call again to see it ->write_iter should be handled - something it's only allowed to do if

ALSA: 6fire: Fix UAF at error handling during probe

In the Linux kernel, the following vulnerability has been resolved: ALSA: 6fire: Fix UAF at error handling during probe Although 6fire driver had a few fixes for dealing with the early error handling during the probe phase, it forgot a pending URB before freeing the resources, which may lead to a UAF. This patch addresses it by doing the almost same cleanup procedure like the normal disconnect phase at the error path.

• Обновитесь до 5.15.0-1117.124

ALSA: usb-audio: fix OOB write in snd_usbmidi_akai_output()

In the Linux kernel, the following vulnerability has been resolved: ALSA: usb-audio: fix OOB write in snd_usbmidi_akai_output() snd_usbmidi_akai_output() computes its fill-loop bound buf_end = ep->max_transfer - MAX_AKAI_SYSEX_LEN - 1; as a signed int, so a small device-advertised bulk-OUT max_transfer makes buf_end negative. The loop guard then compares the u32 urb->transfer_buffer_length against that negative int: the usual arithmetic conversion turns buf_end into a large unsigned value, so the guard stays true and each iteration keeps appending SysEx framing and payload bytes past the end of the URB transfer buffer, which is only max

• Обновитесь до 5.15.0-1117.124

ALSA: usb-audio: Fix DMA buffer out-of-bounds write when fill_max is set

In the Linux kernel, the following vulnerability has been resolved: ALSA: usb-audio: Fix DMA buffer out-of-bounds write when fill_max is set When a USB audio endpoint requests full packet transfers via the fill_max descriptor flag, data_ep_set_params() promotes ep->curpacksize to ep->maxpacksize. However, maxsize is left at the original sample-rate derived value. Since u->buffer_size is allocated as maxsize * packets, the resulting DMA buffer is far too small for the requested transfer length. When the USB host controller streams up to curpacksize bytes per packet, it writes past the end of the buffer via DMA, corrupting kernel heap memory

• Обновитесь до 5.15.0-1117.124

ALSA: usb-audio: Clamp frame size in implicit-feedback mode

In the Linux kernel, the following vulnerability has been resolved: ALSA: usb-audio: Clamp frame size in implicit-feedback mode snd_usb_handle_sync_urb() scales received sync packet sizes by the sender's stride and stores the result directly in out_packet->packet_size[i]. If a connected USB device sends an oversized sync packet, this frame count can exceed ep->maxframesize. The un-clamped frame count then propagates to the playback endpoint queue, potentially driving packet transfers beyond the endpoint's hardware frame limits. Cap the calculated frame count against ep->maxframesize in snd_usb_handle_sync_urb() to prevent oversized packet

• Обновитесь до 5.15.0-1117.124

fou: Fix use-after-free in fou_create()

In the Linux kernel, the following vulnerability has been resolved: fou: Fix use-after-free in fou_create() fou_create() publishes struct fou through sk_user_data before adding the new FOU port to the per-netns list. If fou_add_to_port_list() fails, the error path frees fou while it is still reachable through sk_user_data. A concurrent receive can then dereference the freed object in fou_from_sock(). This ordering issue was previously noted in the linked discussion. The failure is reachable when local port 0 is requested. Each socket binds to a different ephemeral port, but fou_cfg_cmp() compares the requested port 0 and reports -EALRE

• Обновитесь до 5.15.0-1119.126

igbvf: Fix leak in TX DMA error cleanup

In the Linux kernel, the following vulnerability has been resolved: igbvf: Fix leak in TX DMA error cleanup If an error is encountered while mapping TX buffers, the driver should unmap any buffers already mapped for that skb. Because count is incremented before each frag mapping, it will always match the correct number of unmappings needed when dma_error is reached. Decrementing count before the while loop in dma_error causes an off-by-one error. If any mapping was successful before an unsuccessful mapping, exactly one DMA mapping (the head) would leak. This bug was introduced by a 2010 fix for an endless loop in dma_error. All other affe

• Обновитесь до 5.15.0-1117.124

ksmbd: reject repeated SMB2 NEGOTIATE requests

In the Linux kernel, the following vulnerability has been resolved: ksmbd: reject repeated SMB2 NEGOTIATE requests Unauthenticated client can send multiple successful SMB2 NEGOTIATE requests on one connection before SESSION_SETUP. While the connection is in KSMBD_SESS_NEED_SETUP, smb2_handle_negotiate() accepts another SMB3.1.1 NEGOTIATE and overwrites conn->preauth_info with a new allocation. Only the final allocation is freed when the connection is released, leaking one object for every additional successful request. A repeated SMB2 NEGOTIATE after a dialect has been selected is a protocol violation. MS-SMB2 section 3.3.5.4 requires the

• Обновитесь до 5.15.0-1119.126

net/smc: fix socket use-after-free during link group termination

In the Linux kernel, the following vulnerability has been resolved: net/smc: fix socket use-after-free during link group termination __smc_lgr_terminate() drops conns_lock after finding a connection in lgr->conns_all, but before taking a reference on its socket. The connection is embedded in the socket, and its registration reference protects it only while the connection remains in the tree. A concurrent close can unregister the connection and drop that reference, freeing the socket before the termination worker reaches sock_hold(). The race is reachable when close overlaps link group termination. Local stress testing reproduced the use-a

• Обновитесь до 5.15.0-1117.124

netfilter: ipset: do not update comments from kernel-side hash adds

In the Linux kernel, the following vulnerability has been resolved: netfilter: ipset: do not update comments from kernel-side hash adds mtype_resize() copies comment pointers with memcpy(), not the comment objects themselves. During the window after an entry has been copied but before the table swap and backlog replay, the old table is still published for packet-side updates while the replacement-table entry already holds the same ip_set_comment_rcu pointer. If xt_SET --add-set ... --exist hits that old entry in this window, mtype_add() calls ip_set_init_comment() even though packet-side adds carry no comment payload. That call frees the s

• Обновитесь до 5.15.0-1117.124

tipc: avoid use-after-free in poll trace queue dumps

In the Linux kernel, the following vulnerability has been resolved: tipc: avoid use-after-free in poll trace queue dumps TIPC socket tracepoints dump queue state through tipc_sk_dump(). Most queue-dump callsites already serialize that walk under the socket lock or sk->sk_lock.slock, but tipc_poll() calls trace_tipc_sk_poll(..., TIPC_DUMP_ALL, ...) without holding either lock. That lets the poll trace path reach tipc_list_dump() and backlog head/tail dumping while another context dequeues and frees an skb, leaving the trace helper dereferencing a stale queue entry. Stop the unlocked poll trace site from requesting queue dumps. Other queue

• Обновитесь до 5.15.0-1117.124

wifi: mwifiex: use the subframe length when parsing A-MSDU TDLS frames

In the Linux kernel, the following vulnerability has been resolved: wifi: mwifiex: use the subframe length when parsing A-MSDU TDLS frames mwifiex_11n_dispatch_amsdu_pkt() splits an A-MSDU with ieee80211_amsdu_to_8023s() and walks the resulting subframes. For each subframe it passes the subframe data pointer to mwifiex_process_tdls_action_frame(), but pairs it with skb->len, the length of the A-MSDU parent, instead of rx_skb->len: rx_skb = __skb_dequeue(&list); rx_hdr = (struct rx_packet_hdr *)rx_skb->data; if (ISSUPP_TDLS_ENABLED(priv->adapter->fw_cap_info) && ntohs(rx_hdr->eth803_hdr.h_proto) == ETH_P_TDLS) { mwifiex_process_td

• Обновитесь до 5.15.0-1117.124

binfmt_misc: restore write access when removing an entry

In the Linux kernel, the following vulnerability has been resolved: binfmt_misc: restore write access when removing an entry Registering an entry with the MISC_FMT_OPEN_FILE flag opens the interpreter via open_exec() which denies write access to it for as long as the entry exists. Removing the entry closes the interpreter file via filp_close() but never restores write access, leaving the inode's i_writecount permanently negative. Opening the interpreter for writing keeps failing with ETXTBSY long after the entry is gone until the inode is evicted from the inode cache. Commit 90f601b497d7 ("binfmt_misc: restore write access before closing f

• Обновитесь до 5.15.0-1119.126

binfmt_misc: reject a flag character as the field delimiter

In the Linux kernel, the following vulnerability has been resolved: binfmt_misc: reject a flag character as the field delimiter The registration string starts with a user chosen delimiter that separates the individual fields. So that the field parsers terminate even on a truncated string create_entry() pads the buffer with that same delimiter: memset(buf + count, del, 8); Most fields are scanned for the delimiter with strchr()/scanarg() and happily stop on the padding. The flags field is different: instead of scanning for the delimiter check_special_flags() consumes the flag characters 'P', 'O', 'C' and 'F' and stops at the first byte th

• Обновитесь до 5.15.0-1117.124

binfmt_misc: don't let an 'F' entry pin its own instance

In the Linux kernel, the following vulnerability has been resolved: binfmt_misc: don't let an 'F' entry pin its own instance An entry registered with 'F' opens its interpreter at registration time and holds that file until the entry is freed. Any entry nobody removes by hand only gets closed once the binfmt_misc superblock is shut down. If the interpreter lives on a mount that keeps that superblock alive the two pin each other: binfmt_misc sb -> inode -> entry -> interp_file -> vfsmount -> binfmt_misc sb TL;DR the file is never closed. Once the mount namespace is gone there is nothing left to unregister through either. There are two

mm/huge_memory: unlock i_mmap_rwsem before releasing after-split folios

In the Linux kernel, the following vulnerability has been resolved: mm/huge_memory: unlock i_mmap_rwsem before releasing after-split folios __folio_split() keeps dereferencing the mapping after the split: shmem_uncharge(mapping->host) and remap_page() while the folios are still frozen/locked, and i_mmap_unlock_read(mapping) at the very end, after the after-split folios have been unlocked and freed. Nothing holds an inode reference across that. The split relies on @folio -- which the beyond-EOF drop loop never removes, as it starts at folio_next(folio) -- staying locked and in the page cache to hold off eviction. But the unlock loop unloc

• Обновитесь до 5.15.0-1117.124