Уязвимости linux-raspi · Страница 138

nvmet-tcp: Fix potential UAF when ddgst mismatch

In the Linux kernel, the following vulnerability has been resolved: nvmet-tcp: Fix potential UAF when ddgst mismatch Shivam Kumar found via vulnerability testing: When data digest is enabled on an NVMe/TCP connection and a digest mismatch occurs on a non-final H2C_DATA PDU during an R2T-based data transfer, the digest error handler in nvmet_tcp_try_recv_ddgst() calls nvmet_req_uninit() — which performs percpu_ref_put() on the submission queue — but does NOT mark the command as completed. It does not set cqe->status, does not modify rbytes_done, and does not clear any flag. When the subsequent fatal error triggers queue teardown, nvmet_tcp_u

nvmet-tcp: check INIT_FAILED before nvmet_req_uninit in digest error path

In the Linux kernel, the following vulnerability has been resolved: nvmet-tcp: check INIT_FAILED before nvmet_req_uninit in digest error path In nvmet_tcp_try_recv_ddgst(), when a data digest mismatch is detected, nvmet_req_uninit() is called unconditionally. However, if the command arrived via the nvmet_tcp_handle_req_failure() path, nvmet_req_init() had returned false and percpu_ref_tryget_live() was never executed. The unconditional percpu_ref_put() inside nvmet_req_uninit() then causes a refcount underflow, leading to a WARNING in percpu_ref_switch_to_atomic_rcu, a use-after-free diagnostic, and eventually a permanent workqueue deadlock

fs/ntfs3: validate lcns_follow in log_replay conversion

In the Linux kernel, the following vulnerability has been resolved: fs/ntfs3: validate lcns_follow in log_replay conversion log_replay() converts DIR_PAGE_ENTRY_32 records into DIR_PAGE_ENTRY records when replaying version 0 restart tables. During this conversion, the memmove() length is derived directly from the on-disk lcns_follow field: memmove(&dp->vcn, &dp0->vcn_low, 2 * sizeof(u64) + le32_to_cpu(dp->lcns_follow) * sizeof(u64)); check_rstbl() validates restart table structure, but does not constrain per-entry lcns_follow values relative to the entry size. A malformed filesystem image can provide an oversized lcns_follow value

fs/ntfs3: bound NTFS_DE view.data_off in UpdateRecordData{Root,Allocation}

In the Linux kernel, the following vulnerability has been resolved: fs/ntfs3: bound NTFS_DE view.data_off in UpdateRecordData{Root,Allocation} In do_action()'s UpdateRecordDataRoot (fslog.c:3489) and UpdateRecordDataAllocation (fslog.c:3697) cases, the memmove destination is `Add2Ptr(e, le16_to_cpu(e->view.data_off))`, where e->view.data_off comes from an on-disk NTFS_DE inside an INDEX_ROOT or INDEX_BUFFER. Neither case validates view.data_off + dlen against e->size; the existing check_if_index_root / check_if_alloc_index helpers walk the entry chain and validate the entry's offset, but not its internal view fields. The neighbouring read

net: openvswitch: reject oversized nested action attrs

In the Linux kernel, the following vulnerability has been resolved: net: openvswitch: reject oversized nested action attrs Open vSwitch stores generated flow actions as nlattrs, whose nla_len field is u16. Commit a1e64addf3ff ("net: openvswitch: remove misbehaving actions length check") allowed the total sw_flow_actions stream to grow beyond 64 KiB, which is valid, but also removed the last guard preventing a generated nested action attribute from exceeding U16_MAX. An oversized generated container can thus be closed with a truncated nla_len. A later dump or teardown then walks a structurally different stream than the one that was validate

• Обновитесь до 5.15.0-1108.111

net: nexthop: Increase weight to u16

In the Linux kernel, the following vulnerability has been resolved: net: nexthop: Increase weight to u16 In CLOS networks, as link failures occur at various points in the network, ECMP weights of the involved nodes are adjusted to compensate. With high fan-out of the involved nodes, and overall high number of nodes, a (non-)ECMP weight ratio that we would like to configure does not fit into 8 bits. Instead of, say, 255:254, we might like to configure something like 1000:999. For these deployments, the 8-bit weight may not be enough. To that end, in this patch increase the next hop weight from u8 to u16. Increasing the width of an integral

net/sched: cls_api: Handle TC_ACT_CONSUMED in tcf_qevent_handle

In the Linux kernel, the following vulnerability has been resolved: net/sched: cls_api: Handle TC_ACT_CONSUMED in tcf_qevent_handle tcf_classify() can return TC_ACT_CONSUMED while the skb is held by the defragmentation engine (e.g. act_ct on out-of-order fragments). When that happens the skb is no longer owned by the caller and must not be touched again. tcf_qevent_handle() did not handle TC_ACT_CONSUMED: it fell through the switch and returned the skb to the caller as if classification had passed. The only qdisc that wires up qevents today is RED, via three call sites (qe_mark on RED_PROB_MARK/HARD_MARK, qe_early_drop on congestion_drop)

crypto: qat - remove unused character device and IOCTLs

In the Linux kernel, the following vulnerability has been resolved: crypto: qat - remove unused character device and IOCTLs The QAT driver exposes a character device (qat_adf_ctl) with IOCTLs for device configuration, start, stop, status query and enumeration. These IOCTLs are not part of any public uAPI header and have no known in-tree or out-of-tree users. Device lifecycle is already managed via sysfs. The ioctl interface also increases the attack surface and is the subject of a number of bug reports. Remove the character device, the IOCTL definitions, and the related data structures (adf_dev_status_info, adf_user_cfg_key_val, adf_user_

tty: serial: samsung: Remove redundant port lock acquisition in rx helpers

In the Linux kernel, the following vulnerability has been resolved: tty: serial: samsung: Remove redundant port lock acquisition in rx helpers Sashiko identified a deadlock when the console flow is engaged [1]. When console flow control is enabled (UPF_CONS_FLOW), s3c24xx_serial_stop_tx() calls s3c24xx_serial_rx_enable() and s3c24xx_serial_start_tx() calls s3c24xx_serial_rx_disable(). The serial core framework invokes the .stop_tx() and .start_tx() callbacks with the port->lock spinlock already held. Furthermore, all internal driver paths that invoke stop_tx (such as the DMA TX completion handler s3c24xx_serial_tx_dma_complete() or the PI

drm/hyperv: validate VMBus packet size in receive callback

In the Linux kernel, the following vulnerability has been resolved: drm/hyperv: validate VMBus packet size in receive callback hyperv_receive_sub() reads msg->vid_hdr.type and dispatches into one of four message-type branches without knowing how many bytes the host wrote into hv->recv_buf. The completion path then runs memcpy(hv->init_buf, msg, VMBUS_MAX_PACKET_SIZE), so the consumer that wakes on wait_for_completion_timeout() can read up to 16 KiB of residue from a prior message as if it were the response payload. Pass bytes_recvd into hyperv_receive_sub() and reject any packet that does not cover the pipe + synthvid header. A single swit

drm/hyperv: validate resolution_count and fix WIN8 fallback

In the Linux kernel, the following vulnerability has been resolved: drm/hyperv: validate resolution_count and fix WIN8 fallback A SYNTHVID_RESOLUTION_RESPONSE with resolution_count > 64 walks past the supported_resolution[SYNTHVID_MAX_RESOLUTION_COUNT] array in the parse loop. Bound resolution_count against the array size, folded into the existing zero-check. When the WIN10 resolution probe fails, the caller in hyperv_connect_vsp() left hv->screen_*_max / preferred_* unpopulated, which sets mode_config.max_width / max_height to 0 and makes drm_internal_framebuffer_create() reject every userspace framebuffer with -EINVAL. The pre-WIN10 bran

userfaultfd: gate must_wait writability check on pte_present()

In the Linux kernel, the following vulnerability has been resolved: userfaultfd: gate must_wait writability check on pte_present() userfaultfd_must_wait() and userfaultfd_huge_must_wait() read the PTE without taking the page table lock and then apply pte_write() / huge_pte_write() to it. Those accessors decode bits from the present encoding only; on a swap or migration entry they read the offset bits that happen to share the same position and return an undefined result. The intent of the check is "is this fault still WP-blocked?". A non-marker swap entry means the page is in transit -- the userfault context the original fault delivered a

KVM: x86: Unconditionally recompute CR8 intercept on PPR update

In the Linux kernel, the following vulnerability has been resolved: KVM: x86: Unconditionally recompute CR8 intercept on PPR update The TPR_THRESHOLD field in the VMCS is used by VMX to induce VM exits when the guest's virtual TPR falls under the specified threshold, allowing KVM to inject previously masked interrupts. KVM handles these VM exits in handle_tpr_below_threshold(). Commit eb90f3417a0c ("KVM: vmx: speed up TPR below threshold vmexits") optimized this function by calling apic_update_ppr() instead of raising KVM_REQ_EVENT. apic_update_ppr() then raises KVM_REQ_EVENT if there is a pending, deliverable interrupt. However, if there

ACPI: CPPC: Suppress UBSAN warning caused by field misuse

In the Linux kernel, the following vulnerability has been resolved: ACPI: CPPC: Suppress UBSAN warning caused by field misuse The definition of reg->access_width changes depending on the reg->space_id type. Type ACPI_ADR_SPACE_PLATFORM_COMM uses access_width to indicate the PCC region, which can result in a UBSAN if the value is greater than 4. For example: UBSAN: shift-out-of-bounds in drivers/acpi/cppc_acpi.c:1090:9 shift exponent 32 is too large for 32-bit type 'int' CPU: 61 UID: 0 PID: 1220 Comm: (udev-worker) Not tainted 7.0.10-201.fc44.aarch64 #1 PREEMPT(lazy) Hardware name: To be filled by O.E.M. Call trace: ...(trimming)

ACPI: NFIT: core: Fix acpi_nfit_init() error cleanup

In the Linux kernel, the following vulnerability has been resolved: ACPI: NFIT: core: Fix acpi_nfit_init() error cleanup If acpi_nfit_init() fails after adding the acpi_desc object to the acpi_descs list, that object is never removed from that list because the acpi_nfit_shutdown() devm action is not added for the NFIT device in that case. Next, the acpi_nfit_init() failure causes acpi_nfit_probe() to fail, the acpi_desc object is freed, and a dangling pointer is left behind in the acpi_descs. Any subsequent ACPI Machine Check Exception will trigger nfit_handle_mce() which iterates over acpi_descs and so a use-after-free will occur. Moreo

usb: gadget: function: rndis: add length check for header

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: function: rndis: add length check for header Add a length check for the rndis header in rndis_rm_hdr, to ensure that MessageType, MessageLength, DataOffset, and DataLength fields are present before they are accessed.

iio: accel: bmc150: clamp the device-reported FIFO frame count

In the Linux kernel, the following vulnerability has been resolved: iio: accel: bmc150: clamp the device-reported FIFO frame count __bmc150_accel_fifo_flush() copies the number of samples the device reports in its hardware FIFO into an on-stack buffer u16 buffer[BMC150_ACCEL_FIFO_LENGTH * 3]; which is sized for at most BMC150_ACCEL_FIFO_LENGTH (32) samples. The frame count is read from the FIFO_STATUS register and only masked to its 7 valid bits: count = val & 0x7F; so it can be 0..127. The only other limit applied to it is the optional caller-supplied sample budget: if (samples && count > samples) count = samples; which does not

iio: accel: kxsd9: fix runtime PM imbalance on write_raw() error

In the Linux kernel, the following vulnerability has been resolved: iio: accel: kxsd9: fix runtime PM imbalance on write_raw() error kxsd9_write_raw() takes a runtime PM reference with pm_runtime_get_sync() but returns -EINVAL directly when a scale with a non-zero integer part is requested, skipping the matching pm_runtime_put_autosuspend(). This leaks a runtime PM usage-counter reference on every such write, after which the device can no longer autosuspend. Set the error code and fall through to the existing put instead of returning early.

iio: adc: lpc32xx: Initialize completion before requesting IRQ

In the Linux kernel, the following vulnerability has been resolved: iio: adc: lpc32xx: Initialize completion before requesting IRQ In the report from Jaeyoung Chung: "lpc32xx_adc_probe() in drivers/iio/adc/lpc32xx_adc.c registers its interrupt handler with devm_request_irq() before it initializes st->completion with init_completion(). If an interrupt arrives after devm_request_irq() and before init_completion(), the handler calls complete() on an uninitialized completion, causing a kernel panic. The probe path, in lpc32xx_adc_probe(): iodev = devm_iio_device_alloc(&pdev->dev, sizeof(*st)); /* st kzalloc-zeroed */ ... retval =

iio: chemical: scd30: Cleanup initializations and fix sign-extension bug

In the Linux kernel, the following vulnerability has been resolved: iio: chemical: scd30: Cleanup initializations and fix sign-extension bug Include linux/bitfield.h for FIELD_GET(). Create new macros for bit manipulation in combination with manual bit manipulation being replaced with FIELD_GET(). The current variable declaration and initializations are barely readable and use comma separations across multiple lines. Refactor the initializations so that mantissa and exp have separate declarations and sign gets initialized later. In addition (and due to the nature of the cleanup), fix a sign-extension bug where, float32 would get bitwise