Уязвимости linux-riscv-6.8 · Страница 189

powerpc/time: Remove redundant preempt_disable|enable() calls from arch_irq_work_raise()

In the Linux kernel, the following vulnerability has been resolved: powerpc/time: Remove redundant preempt_disable|enable() calls from arch_irq_work_raise() A kernel panic is observed when handling machine check exceptions from real mode. BUG: Unable to handle kernel data access on read at 0xc00000006be21300 Oops: Kernel access of bad area, sig: 11 [#1] MSR: 8000000000001003 <SF,ME,RI,LE> CR: 88222248 XER: 00000005 CFAR: c00000000003ffc4 DAR: c00000006be21300 DSISR: 40000000 IRQMASK: 0 NIP [c000000000029e40] arch_irq_work_raise+0x10/0x70 LR [c00000000003ffc8] machine_check_queue_event+0xa8/0x150 Call Trace: [c0000000179d

• Обновитесь до 6.8.0-139.139~22.04.1

hwmon: (lm90) Add lock protection to lm90_alert

In the Linux kernel, the following vulnerability has been resolved: hwmon: (lm90) Add lock protection to lm90_alert Sashiko reports: lm90_alert() executes in the smbus alert context and calls lm90_update_confreg() to disable the hardware alert line, without acquiring hwmon_lock. Concurrently, sysfs write operations (such as lm90_write_convrate) hold the hwmon_lock, temporarily modify data->config, and then restore it. If an alert interrupt occurs concurrently with a sysfs write, the sysfs path will overwrite the alert handler's modifications to data->config and the hardware register. This unintentionally re-enables the hardware alert li

net/mlx5e: xsk: Fix unlocked writing to ICOSQ

In the Linux kernel, the following vulnerability has been resolved: net/mlx5e: xsk: Fix unlocked writing to ICOSQ During napi poll, when the affinity changes and there's still XSK work to be done, we trigger an ICOSQ interrupt on the new CPU. However, this triggering on the ICOSQ is done unprotected. There are 2 such races: A) mlx5e_trigger_irq() is called while mlx5e_xsk_alloc_rx_mpwqe() is running from a different CPU due to affinity change. This can happen because IRQ triggering is done after napi_complete_done(). At this point the NAPI can be scheduled on a different CPU. Like this: CPU A (old affinity, NAPI tail) CPU B (new aff

xfs: resample the data fork mapping after cycling ILOCK

In the Linux kernel, the following vulnerability has been resolved: xfs: resample the data fork mapping after cycling ILOCK xfs_reflink_fill_{cow_hole,delalloc} are both presented with an inode, a data fork mapping, and a cow fork mapping. Unfortunately, these two helpers cycle the ILOCK to grab a transaction, which means that the mappings are stale as soon as we reacquire the ILOCK. Currently we refresh the cow fork mapping by re-calling xfs_find_trim_cow_extent, but we don't refresh the data fork mapping beforehand, which means that the xfs_bmap_trim_cow in that function queries the refcount btree about the wrong physical blocks and ret

Bluetooth: L2CAP: cancel pending_rx_work before taking conn->lock

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: L2CAP: cancel pending_rx_work before taking conn->lock l2cap_conn_del() takes conn->lock and then calls cancel_work_sync() for pending_rx_work. process_pending_rx() takes the same mutex, so teardown can deadlock against the worker it is flushing. This issue was found by our static analysis tool and then manually reviewed against the current tree. The grounded PoC kept the l2cap_conn_ready() -> queue_work(..., &conn->pending_rx_work) submit path, the l2cap_conn_del() -> cancel_work_sync(&conn->pending_rx_work) teardown path, and the process_pending_rx() -> mute

i2c: i801: fix hardware state machine corruption in error path

In the Linux kernel, the following vulnerability has been resolved: i2c: i801: fix hardware state machine corruption in error path A severe livelock and subsequent Hung Task panic were observed in the i2c-i801 driver during concurrent Fuzzing. The crash is caused by an unconditional hardware register cleanup in the error handling path of i801_access(). When i801_check_pre() fails (e.g., returning -EBUSY because the SMBus controller is actively used by BIOS/ACPI), the kernel does not actually acquire the hardware ownership. However, the code jumps to the 'out' label and executes: iowrite8(SMBHSTSTS_INUSE_STS | STATUS_FLAGS, SMBHSTSTS(p

bpf: Reject BPF_MAP_TYPE_INODE_STORAGE creation if BPF LSM is uninitialized

In the Linux kernel, the following vulnerability has been resolved: bpf: Reject BPF_MAP_TYPE_INODE_STORAGE creation if BPF LSM is uninitialized When CONFIG_BPF_LSM=y is set, BPF inode storage maps (BPF_MAP_TYPE_INODE_STORAGE) are compiled into the kernel. However, if the BPF LSM is not explicitly enabled at boot time (e.g. omitted from the "lsm=" boot parameter), lsm_prepare() is never executed for the BPF LSM. Consequently, the BPF inode security blob offset (bpf_lsm_blob_sizes.lbs_inode) is never initialized and remains at its default compiled size of 8 bytes instead of being updated to a valid offset past the reserved struct rcu_head (t

i2c: stub: Reject I2C block transfers with invalid length

In the Linux kernel, the following vulnerability has been resolved: i2c: stub: Reject I2C block transfers with invalid length The I2C_SMBUS_I2C_BLOCK_DATA case in stub_xfer() uses data->block[0] as the transfer length. The existing check only clamps it to avoid overrunning the chip->words[256] register array, but does not validate it against I2C_SMBUS_BLOCK_MAX (32), which is the limit of the union i2c_smbus_data.block buffer (34 bytes total). The driver is a development/test tool (CONFIG_I2C_STUB=m, not built by default) that must be loaded with a chip_addr= parameter. A local user with access to /dev/i2c-* can issue an I2C_SMBUS ioctl wi

net: team: fix NULL pointer dereference in team_xmit during mode change

In the Linux kernel, the following vulnerability has been resolved: net: team: fix NULL pointer dereference in team_xmit during mode change __team_change_mode() clears team->ops with memset() before restoring safe dummy handlers via team_adjust_ops(). A concurrent team_xmit() running under RCU on another CPU can read team->ops.transmit during this window and call a NULL function pointer, crashing the kernel. The race requires a mode change (CAP_NET_ADMIN) concurrent with transmit on the team device. BUG: kernel NULL pointer dereference, address: 0000000000000000 Oops: 0010 [#1] SMP KASAN NOPTI RIP: 0010:0x0 Call Trace: team_xmit (dr

netfilter: ipset: fix race between dump and ip_set_list resize

In the Linux kernel, the following vulnerability has been resolved: netfilter: ipset: fix race between dump and ip_set_list resize The release path of ip_set_dump_do() and ip_set_dump_done() read inst->ip_set_list via ip_set_ref_netlink(), a plain rcu_dereference_raw() of the array pointer. These run from netlink_recvmsg() without the nfnl mutex and without an RCU read-side critical section. A concurrent ip_set_create() can grow the array: it publishes the new array, calls synchronize_net() and then kvfree()s the old one. Since the dump paths read the array outside any RCU reader, synchronize_net() does not wait for them and the old array

net: qualcomm: rmnet: fix endpoint use-after-free in rmnet_dellink()

In the Linux kernel, the following vulnerability has been resolved: net: qualcomm: rmnet: fix endpoint use-after-free in rmnet_dellink() rmnet_dellink() removes the endpoint from the hash table with hlist_del_init_rcu() and then immediately frees it with kfree(). However, RCU readers on the receive path (rmnet_rx_handler -> __rmnet_map_ingress_handler) may still hold a reference to the endpoint and dereference ep->egress_dev after the memory has been freed. The endpoint is a kmalloc-32 object, and the stale read at offset 8 corresponds to the egress_dev pointer. BUG: unable to handle page fault for address: ffffffffde942eef Oops: 0002

xfs: fail recovery on a committed log item with no regions

In the Linux kernel, the following vulnerability has been resolved: xfs: fail recovery on a committed log item with no regions If the first op of a transaction is a bare transaction header (len == sizeof(struct xfs_trans_header)), xlog_recover_add_to_trans() adds an item but no region, leaving it on r_itemq with ri_cnt == 0 and ri_buf == NULL. The header can be split across op records, so later ops may still add regions; the item is only invalid if the transaction commits with none. The runtime commit path never emits such a transaction, so this only happens on a crafted log. It came from an AI-assisted code audit of the recovery parser.

sysfs: don't remove existing directory on update failure

In the Linux kernel, the following vulnerability has been resolved: sysfs: don't remove existing directory on update failure When sysfs_update_group() is called for a named group and create_files() fails (e.g. -ENOMEM), internal_create_group() calls kernfs_remove(kn) on the group directory. In the update path, kn was obtained via kernfs_find_and_get() and refers to a directory that already existed before this call. Removing it silently destroys a sysfs group that the caller did not create. Only remove the directory if we created it ourselves. On update failure the directory remains as it is left empty by remove_files() inside create_fil

• Обновитесь до 6.8.0-139.139~22.04.1

mm/damon/sysfs-schemes: call missing mem_cgroup_iter_break()

In the Linux kernel, the following vulnerability has been resolved: mm/damon/sysfs-schemes: call missing mem_cgroup_iter_break() damon_sysfs_memcg_path_to_id() breaks mem_cgroup_iter() loop without calling mem_cgroup_iter_break(). This leaks the cgroup reference. Fix the issue by calling mem_cgroup_iter_break() before the break. The issue was discovered [1] by Sashiko.

• Обновитесь до 6.8.0-139.139~22.04.1

efi: Allocate runtime workqueue before ACPI init

In the Linux kernel, the following vulnerability has been resolved: efi: Allocate runtime workqueue before ACPI init Since commit 5894cf571e14 ("acpi/prmt: Use EFI runtime sandbox to invoke PRM handlers") ACPI PRM calls are delegated to a workqueue which runs in a kernel thread, making it easier to detect and mitigate faulting memory accesses performed by the firmware. Rafael reports that such PRM accesses may occur before efisubsys_init() executes, which is where the workqueue is allocated, leading to NULL pointer dereferences. Since acpi_init() [which triggers the early PRM accesses] executes as a subsys_initcall() as well, and has i

• Обновитесь до 6.8.0-139.139~22.04.1

drivers/base/memory: fix memory block reference leak in poison accounting

In the Linux kernel, the following vulnerability has been resolved: drivers/base/memory: fix memory block reference leak in poison accounting memblk_nr_poison_inc() and memblk_nr_poison_sub() look up a memory block via find_memory_block_by_id(), which acquires a reference to the memory block device. Both helpers use the returned memory block without dropping that reference, leaking the device reference on each successful lookup. Drop the reference after updating nr_hwpoison.

• Обновитесь до 6.8.0-139.139~22.04.1

mm/memory_hotplug: fix memory block reference leak on remove

In the Linux kernel, the following vulnerability has been resolved: mm/memory_hotplug: fix memory block reference leak on remove Patch series "mm: Fix memory block leaks and locking", v2. This series fixes two memory block device reference leaks and one locking issue around the per-memory_block hwpoison counter. This patch (of 2): remove_memory_blocks_and_altmaps() looks up each memory block with find_memory_block(), which acquires a reference to the memory block device. That reference is never dropped on this path, resulting in a leaked device reference when removing memory blocks and their altmaps. Drop the reference after retrievin

• Обновитесь до 6.8.0-139.139~22.04.1

net: wwan: iosm: fix potential memory leaks in ipc_imem_init()

In the Linux kernel, the following vulnerability has been resolved: net: wwan: iosm: fix potential memory leaks in ipc_imem_init() The memory allocated in ipc_protocol_init() is not freed on the error paths that follow in ipc_imem_init(). Fix that by calling the corresponding release function ipc_protocol_deinit() in the error path.

• Обновитесь до 6.8.0-139.139~22.04.1

Bluetooth: bnep: Fix UAF read of dev->name

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: bnep: Fix UAF read of dev->name bnep_add_connection() needs to keep holding the bnep_session_sem while reading dev->name (just like bnep_get_connlist() does); otherwise the bnep_session() thread can concurrently free the net_device, which can for example be triggered by a concurrent bnep_del_connection(). (This UAF is fairly uninteresting from a security perspective; calling bnep_add_connection() requires passing a capable(CAP_NET_ADMIN) check. It also requires completely tearing down a netdev during a fairly tight race window.)

• Обновитесь до 6.8.0-139.139~22.04.1

phonet/pep: disable BH around forwarded sk_receive_skb()

In the Linux kernel, the following vulnerability has been resolved: phonet/pep: disable BH around forwarded sk_receive_skb() The networking receive path is usually run from softirq context, but protocols that take the socket lock may have packets stored in the backlog and processed later from process context. In that case release_sock() -> __release_sock() drops the slock with spin_unlock_bh() and then calls sk->sk_backlog_rcv() with bottom halves enabled. Typical sk_backlog_rcv handlers process the socket whose backlog is being drained, so the BH state at entry is irrelevant for the slocks they touch. pep_do_rcv() is different: when the i

• Обновитесь до 6.8.0-139.139~22.04.1