Уязвимости linux-gcp · Страница 158

ieee802154: ca8210: fix pointer truncation in kfifo on 64-bit

In the Linux kernel, the following vulnerability has been resolved: ieee802154: ca8210: fix pointer truncation in kfifo on 64-bit ca8210_test_int_driver_write() and ca8210_test_int_user_read() exchange a kmalloc'd buffer pointer through a struct kfifo, but pass a literal '4' as the byte count to kfifo_in()/kfifo_out(). This is correct on 32-bit (pointer = 4 bytes), but on 64-bit only the low 4 bytes of the 8-byte pointer are written into the FIFO. The reader then reads back 4 bytes into an 8-byte local pointer variable, leaving the upper 4 bytes uninitialized stack data. The first dereference of the reconstructed pointer (fifo_buffer[1]) a

• Обновитесь до 6.8.0-1071.79

gve: fix header buffer corruption with header-split and HW-GRO

In the Linux kernel, the following vulnerability has been resolved: gve: fix header buffer corruption with header-split and HW-GRO The DQO RX datapath programs a per-buffer-queue-descriptor header_buf_addr at post time and reads the split header back at completion time. Both the post and the read currently index the header buffer by queue position rather than by the buffer's identity: - post (gve_rx_post_buffers_dqo): header_buf_addr is computed from bufq->tail - read (gve_rx_dqo): the header is read from desc_idx (the completion queue head index) This relies on the buffer-queue index and the completion-queue index being equal

• Обновитесь до 6.8.0-1070.78

octeontx2-af: cn10k: restrict VF LMTLINE sharing to its own PF

In the Linux kernel, the following vulnerability has been resolved: octeontx2-af: cn10k: restrict VF LMTLINE sharing to its own PF rvu_mbox_handler_lmtst_tbl_setup() uses req->base_pcifunc as a direct index into the LMT map table to read another function's LMTLINE physical base address and copy it into the caller's own LMT map table entry. The mailbox dispatcher authenticates req->hdr.pcifunc from the IRQ source, but req->base_pcifunc is a separate payload field and is not sanitized. Reject the request with -EPERM when a VF caller's base_pcifunc is not a valid function under its own PF. is_pf_func_valid() bounds the FUNC field to the PF's

• Обновитесь до 6.8.0-1071.79

ipmi: Fix user refcount underflow in event delivery

In the Linux kernel, the following vulnerability has been resolved: ipmi: Fix user refcount underflow in event delivery ipmi_alloc_recv_msg(user) takes the temporary user reference owned by the receive message, and ipmi_free_recv_msg() drops it again. If event delivery fails after allocating receive messages for earlier users, handle_read_event_rsp() rolls those messages back with ipmi_free_recv_msg(). That rollback path still drops user->refcount explicitly after freeing each message. The extra put can free a user that remains linked on intf->users, so later event delivery may dereference a freed user or trip refcount_t's addition-on-zero

espintcp: use sk_msg_free_partial to fix partial send

In the Linux kernel, the following vulnerability has been resolved: espintcp: use sk_msg_free_partial to fix partial send sk_msg_free_partial() ensures consistency of the skmsg at every iteration, without having to manually handle uncharges and offsets. This simplifies the code, and fixes some bugs in skmsg accounting when we don't send the full contents.

• Обновитесь до 6.8.0-1071.79

ipmi: fix refcount leak in i_ipmi_request()

In the Linux kernel, the following vulnerability has been resolved: ipmi: fix refcount leak in i_ipmi_request() When a caller provides a `supplied_recv` message to i_ipmi_request(), the function increments the user's `nr_msgs` reference count. If an error occurs later, the out_err cleanup path only frees the recv_msg if the function allocated it itself (i.e., !supplied_recv). In the supplied_recv case the cleanup is skipped, leaving the reference count elevated. The caller ipmi_request_supply_msgs() does not release the supplied_recv on error, so the reference is permanently leaked. Fix this by explicitly reverting the reference count oper

• Обновитесь до 6.8.0-1071.79

bnx2x: fix potential memory leak in bnx2x_alloc_mem_bp()

In the Linux kernel, the following vulnerability has been resolved: bnx2x: fix potential memory leak in bnx2x_alloc_mem_bp() If the allocation of fp[i].tpa_info fails, the error path will not free the struct bnx2x_fastpath allocated earlier, as it is not linked to the bp structure yet. Fix that by linking it immediately after allocation.

• Обновитесь до 6.8.0-1071.79

net: liquidio: fix BAR resource leak on PF number failure

In the Linux kernel, the following vulnerability has been resolved: net: liquidio: fix BAR resource leak on PF number failure If cn23xx_get_pf_num() fails, the function returns without unmapping either BAR. Unmap both BARs before returning from the error path. Found by manual code review.

• Обновитесь до 6.8.0-1071.79

net: lan743x: Initialize eth_syslock spinlock before use

In the Linux kernel, the following vulnerability has been resolved: net: lan743x: Initialize eth_syslock spinlock before use lan743x_hardware_init() calls pci11x1x_strap_get_status() during the PCI11x1x probe sequence. That helper acquires the Ethernet subsystem hardware lock via lan743x_hs_syslock_acquire(), which relies on adapter->eth_syslock_spinlock to serialize access. The spinlock is currently initialized only after the strap status is read. With CONFIG_DEBUG_SPINLOCK enabled, taking the zeroed initialized spinlock can trip the spinlock debug check. Fix by initializing adapter->eth_syslock_spinlock before reading the strap status s

• Обновитесь до 6.8.0-1071.79

net/sched: sch_multiq: Replace direct dequeue call with peek and qdisc_dequeue_peeked

In the Linux kernel, the following vulnerability has been resolved: net/sched: sch_multiq: Replace direct dequeue call with peek and qdisc_dequeue_peeked multiq_dequeue() takes a packet from a band's child with a direct ->dequeue() call after multiq_peek() peeked it. When the child is non-work-conserving the peek stashes the skb in the child's gso_skb, so the direct dequeue returns a different skb and orphans the stash, desyncing the child's qlen/backlog. With a qfq child reached through a peeking parent (e.g. tbf) this re-enters the child on an emptied list and dereferences NULL, panicking the kernel from softirq on ordinary egress. Take

• Обновитесь до 6.8.0-1071.79

net/sched: sch_taprio: Replace direct dequeue call with peek and qdisc_dequeue_peeked

In the Linux kernel, the following vulnerability has been resolved: net/sched: sch_taprio: Replace direct dequeue call with peek and qdisc_dequeue_peeked When taprio's software path peeks a non-work-conserving child qdisc, the child stashes the peeked skb in its gso_skb; taprio_dequeue_from_txq() then takes the packet with a direct child ->dequeue() call, which ignores that stash, orphans the peeked skb and desyncs the child's qlen/backlog. With a qfq child this re-enters the child on an emptied list and dereferences NULL, panicking the kernel from softirq on ordinary egress. Take the packet through qdisc_dequeue_peeked(), as sch_red and s

• Обновитесь до 6.8.0-1071.79

orangefs: keep the readdir entry size 64-bit in fill_from_part()

In the Linux kernel, the following vulnerability has been resolved: orangefs: keep the readdir entry size 64-bit in fill_from_part() fill_from_part() computes the size of a directory entry in size_t but stores it in a __u32. An entry length near U32_MAX wraps it to a small value, bypasses the bounds check, and is then used to index the entry, reading far past the directory part -- an out-of-bounds read that oopses the kernel. Compute the size as a u64 so it cannot truncate; the bounds check then rejects the entry. The trailer is supplied by the userspace client.

• Обновитесь до 6.8.0-1071.79

ata: libata-core: Reject an invalid concurrent positioning ranges count

In the Linux kernel, the following vulnerability has been resolved: ata: libata-core: Reject an invalid concurrent positioning ranges count ata_dev_config_cpr() takes the number of range descriptors from buf[0] of the concurrent positioning ranges log (up to 255), which the device reports independently of the log size in the GPL directory. The count is then walked at a fixed 32-byte stride in two places with no bound: the log read here, and the INQUIRY VPD page B9h emitter, which writes one descriptor per range into the fixed 2048-byte ata_scsi_rbuf. A device reporting a count larger than its own log overflows the read buffer (up to 7704 by

• Обновитесь до 6.8.0-1071.79

net: wwan: iosm: bound device offsets in the MUX downlink decoder

In the Linux kernel, the following vulnerability has been resolved: net: wwan: iosm: bound device offsets in the MUX downlink decoder mux_dl_adb_decode() walks a chain of aggregated datagram tables using offsets and lengths taken from the modem. first_table_index, next_table_index, table_length, datagram_index and datagram_length are all device supplied le values. Only first_table_index was checked, and only for being non zero. The decoder then formed adth = block + adth_index and read the table header and the datagram entries with no bound against the received skb. A modem that reports an index or a length past the downlink buffer makes th

• Обновитесь до 6.8.0-1071.79

riscv: probes: save original sp in rethook trampoline

In the Linux kernel, the following vulnerability has been resolved: riscv: probes: save original sp in rethook trampoline Reading a word from the stack in a kretprobe crashes a risc-v kernel. $ cd /sys/kernel/tracing/ $ echo 'r n_tty_write $stack0' > dynamic_events $ echo 1 > events/kprobes/enable Unable to handle kernel paging request at virtual address 0000000200000128 ... [<ffffffff80016d16>] regs_get_kernel_stack_nth+0x26/0x38 [<ffffffff80177196>] process_fetch_insn+0x3ee/0x760 [<ffffffff80177836>] kretprobe_trace_func+0x116/0x1f0 [<ffffffff8017795a>] kretprobe_dispatcher+0x4a/0x58 [<ffffffff8013572e>] kretprobe_rethook_handler+0x5e/0x

• Обновитесь до 6.8.0-1071.79

s390/monwriter: Reject buffer reuse with different data length

In the Linux kernel, the following vulnerability has been resolved: s390/monwriter: Reject buffer reuse with different data length When data buffers are reused, e.g. for interval sample records, the first record determines the data length, and the size of the buffer for user copy. Current monwriter code does not check if the data length was changed for subsequent records, which also would never happen for valid user programs. However, a malicious user could change the data length, resulting in out of bounds user copy to the kernel buffer, and memory corruption. By default, the monwriter misc device is created with root-only permissions, so

• Обновитесь до 6.8.0-1071.79

mac802154: remove interfaces with RCU list deletion

In the Linux kernel, the following vulnerability has been resolved: mac802154: remove interfaces with RCU list deletion Queue wake, stop, and disable paths walk local->interfaces under RCU. The bulk hardware teardown path removes entries with list_del(), so an asynchronous transmit completion can follow a poisoned list node in ieee802154_wake_queue(). Use list_del_rcu() as in the single-interface removal path. The following unregister_netdevice() waits for in-flight RCU readers before freeing the netdevice, so no separate grace-period wait is needed.

• Обновитесь до 6.8.0-1071.79

octeontx2-pf: fix SQB pointer leak on init failure

In the Linux kernel, the following vulnerability has been resolved: octeontx2-pf: fix SQB pointer leak on init failure otx2_init_hw_resources() initializes SQ aura and pool resources before several later setup steps. On failure, err_free_sq_ptrs only frees SQB pages, leaving the per-SQ sqb_ptrs arrays behind. Use otx2_free_sq_res() for the SQ unwind path and let it free sqb_ptrs even when sq->sqe has not been allocated yet. The bug was first flagged by an experimental analysis tool we are developing for kernel memory-management bugs while analyzing v6.13-rc1. The tool is still under development and is not yet publicly available. Manual in

• Обновитесь до 6.8.0-1071.79

llc: fix SAP refcount leak in llc_ui_autobind()

In the Linux kernel, the following vulnerability has been resolved: llc: fix SAP refcount leak in llc_ui_autobind() llc_ui_autobind() opens a SAP after choosing a dynamic LSAP. llc_sap_open() returns a reference owned by the caller, and llc_sap_add_socket() takes a second reference for the socket's membership in the SAP hash tables. llc_ui_bind() drops the caller's reference after adding the socket, but llc_ui_autobind() keeps it. When the socket is closed, llc_sap_remove_socket() releases only the socket reference, leaving the SAP on llc_sap_list with sk_count == 0. This is user-visible because repeated autobind and close cycles can cons

• Обновитесь до 6.8.0-1071.79

ipvs: use parsed transport offset in SCTP state lookup

In the Linux kernel, the following vulnerability has been resolved: ipvs: use parsed transport offset in SCTP state lookup set_sctp_state() reads the SCTP chunk header again in order to drive the IPVS SCTP state table. For IPv6 it computes the offset with sizeof(struct ipv6hdr), while the surrounding IPVS code uses iph.len from ip_vs_fill_iph_skb(), where ipv6_find_hdr() has already skipped extension headers and found the real transport header. This makes the state machine read from the wrong offset for IPv6 SCTP packets that carry extension headers. For example, an INIT packet with an 8-byte destination options header can be scheduled cor

• Обновитесь до 6.8.0-1071.79