smb: client: fix use-before-check of ReparseDataLength in reparse_buf_ptr()
In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix use-before-check of ReparseDataLength in reparse_buf_ptr()
reparse_buf_ptr() reads buf->ReparseDataLength before checking that
count covers the full fixed header:
buf = (struct reparse_data_buffer *)((u8 *)io + off);
len = sizeof(*buf); /* 8 bytes */
rdlen = le16_to_cpu(buf->ReparseDataLength); /* offset 4, 2 bytes */
if (count < len || count < rdlen + len) /* check comes after */
struct reparse_data_buffer has ReparseDataLength at offset 4. If a
server returns OutputCount < 6, the read at offset 4-5 reaches
smb: client: reject a tree connect response whose byte count is too small
In the Linux kernel, the following vulnerability has been resolved:
smb: client: reject a tree connect response whose byte count is too small
CIFSTCon() bounds its strnlen() over the byte area with the server's
ByteCount minus two, which for ByteCount 0 or 1 goes negative as an int
and converts to a huge size_t. The later subtraction wraps the __u16
bytes_left, and that is what bounds cifs_strndup_from_utf16(): a bound of
up to 65535 against a ~16 KB cifs_req_poolp object runs off the end of the
slab object, and the bytes reach userspace through tcon->nativeFileSystem
in /proc/fs/cifs/DebugData.
Reject a byte area too small for what the p
smb: client: restore the data_offset bound in is_valid_oplock_break()
In the Linux kernel, the following vulnerability has been resolved:
smb: client: restore the data_offset bound in is_valid_oplock_break()
Commit 83bfbd0bb902 ("cifs: Remove the RFC1002 header from smb_hdr")
changed the quantity this bound is measured against. It used to be
srv->total_read minus the 4-byte RFC1002 preamble that total_read then
included, so it was the SMB message length. The same commit stopped
counting the preamble, and the mechanical substitution to
srv->total_read - srv->pdu_size left an expression that is identically
zero: standard_receive3() reads MID_HEADER_SIZE() bytes and then exactly
pdu_length - MID_HEADER_SIZE()
HID: corsair-void: Check size of status and firmware events before reading them
In the Linux kernel, the following vulnerability has been resolved:
HID: corsair-void: Check size of status and firmware events before reading them
Malformed status and firmware events could cause an out-of-bounds read since
the size wasn't being checked. Check the size and warn on unexpected values to
avoid this.
HID: picolcd: clamp eeprom debugfs read to bytes actually received
In the Linux kernel, the following vulnerability has been resolved:
HID: picolcd: clamp eeprom debugfs read to bytes actually received
picolcd_debug_eeprom_read() trusts resp->raw_data[2] -- a length byte
supplied by the device in its REPORT_EE_DATA reply -- clamped only to
the caller's read() count:
ret = resp->raw_data[2];
if (ret > s)
ret = s;
if (copy_to_user(u, resp->raw_data+3, ret))
It never checks resp->raw_size, the number of bytes picolcd_raw_event()
actually copied into the 64-byte raw_data[] of the kmalloc'd struct
picolcd_pending. A device (or a spoofed picoLCD) returning a length byte
of 0xff, read with a count >= 255,
HID: roccat: free buffered reports when destroying device
In the Linux kernel, the following vulnerability has been resolved:
HID: roccat: free buffered reports when destroying device
roccat_report_event() duplicates each report with kmemdup() and stores
the allocation in a circular-buffer slot. The allocation is released only
when that slot is reused.
The device destruction paths free struct roccat_device without releasing
reports still stored in cbuf[]. This makes those allocations unreachable
and leaks up to ROCCAT_CBUF_SIZE report buffers per device.
Add a small destructor that frees every buffered report before freeing the
device, and use it in both paths that can destroy a registered devic
HID: sensor: custom: Fix field sysfs group cleanup on failure
In the Linux kernel, the following vulnerability has been resolved:
HID: sensor: custom: Fix field sysfs group cleanup on failure
hid_sensor_custom_add_attributes() creates one sysfs group for each
custom sensor field. If sysfs_create_group() fails after some groups
have already been created, the function returns the error without
removing the previously created groups.
Add a local unwind path to remove the groups that were already created.
With enable_sensor exposed only after the field attributes are ready,
this path can free sensor_inst->fields without leaving enable_sensor
able to access pointers into that array.
HID: sony: fix UAF of ghl_poke_timer / ghl_urb at driver unbind
In the Linux kernel, the following vulnerability has been resolved:
HID: sony: fix UAF of ghl_poke_timer / ghl_urb at driver unbind
For GHL (Guitar Hero Live) dongles, sony_probe() arms a periodic timer:
ghl_magic_poke() (the timer callback) submits sc->ghl_urb, and the URB
completion ghl_magic_poke_cb() re-arms the timer with mod_timer().
sony_remove() drained the timer with timer_delete_sync() and then freed
the URB with usb_free_urb():
timer_delete_sync(&sc->ghl_poke_timer);
usb_free_urb(sc->ghl_urb);
timer_delete_sync() does not block re-arming, and while the URB is in
flight the timer is not pending, so the sync delete is a no-op.
HID: universal-pidff: stop the device when force-feedback init fails
In the Linux kernel, the following vulnerability has been resolved:
HID: universal-pidff: stop the device when force-feedback init fails
universal_pidff_probe() starts the device with hid_hw_start() and then, if
force-feedback initialisation fails, returns the error through a label that
only does "return error". The device is left started.
The HID core does not unwind on the driver's behalf. __hid_device_probe()
releases the devres group, closes the report and clears hdev->driver:
if (ret) {
devres_release_group(&hdev->dev, hdev->devres_group_id);
hid_close_report(hdev);
hdev->driver = NULL;
}
The hidraw character device that h
In the Linux kernel, the following vulnerability has been resolved:
HID: mcp2221: stop device IO before hid_hw_stop
Quiesce device IO at the start of the devm cleanup callback
mcp2221_hid_unregister() so that incoming HID reports cannot race with
hardware teardown during probe failure or device removal, addressing a
potential use-after-free.
Guard the call to hid_device_io_stop() with io_started. On normal
removal hid_device_remove() has already cleared io_started before the
devres group is released, so an unconditional call would otherwise hit
the !io_started path and emit a spurious "io already stopped" warning
on every removal. The guar
HID: mcp2221: clear rxbuf after I2C/SMBus transfer completes
In the Linux kernel, the following vulnerability has been resolved:
HID: mcp2221: clear rxbuf after I2C/SMBus transfer completes
mcp_i2c_smbus_read() stores the caller-supplied buffer pointer in
mcp->rxbuf for the duration of a transfer but never clears it when the
transfer finishes or times out. Once the caller frees or reuses the
buffer, mcp->rxbuf becomes a dangling pointer. A delayed or spurious
MCP2221_I2C_GET_DATA report can then drive mcp2221_raw_event() to
memcpy device data into the freed memory, causing a write
use-after-free.
Route all return paths through a single exit point that clears
mcp->rxbuf and mcp->rxbuf_size, so that t
HID: mcp2221: validate report size in mcp2221_raw_event()
In the Linux kernel, the following vulnerability has been resolved:
HID: mcp2221: validate report size in mcp2221_raw_event()
mcp2221_raw_event() never validates the size of incoming HID reports.
In the MCP2221_I2C_GET_DATA path it trusts the device-supplied data[3]
as the copy length without checking that 4 + data[3] bytes actually
exist in the received report. A malicious or misbehaving USB device can
send a short report with a large data[3], causing the memcpy to read
past the valid report data in the HID transfer buffer and leak
uninitialized kernel memory back to userspace through the I2C/SMBus
read path.
Add a minimum size check at e
HID: intel-thc-hid: intel-quickspi: validate report size before copy
In the Linux kernel, the following vulnerability has been resolved:
HID: intel-thc-hid: intel-quickspi: validate report size before copy
write_cmd_to_txdma() builds an output report in qsdev->report_buf, a heap
buffer allocated in quickspi_alloc_report_buf() to the device-descriptor
derived max_report_len (a few hundred bytes for a touch controller). It
copies the caller-supplied report into that buffer:
memcpy(write_buf->content, report_buf, report_buf_len);
The HID core caps a report at HID_MAX_BUFFER_SIZE (16384) by default, and
quickspi_hid_ll_driver does not set max_buffer_size, so the length reaches
the driver unbounded. A hid
HID: intel-thc-hid: intel-quickspi: bound GET_REPORT response to the caller buffer
In the Linux kernel, the following vulnerability has been resolved:
HID: intel-thc-hid: intel-quickspi: bound GET_REPORT response to the caller buffer
quickspi_hid_raw_request() receives the caller's buffer length in len, but
quickspi_get_report() never sees it and copies the whole device-supplied
response into buf regardless:
memcpy(buf, qsdev->report_buf, qsdev->report_len);
qsdev->report_len comes from the input report the touch controller returns,
while buf is sized to whatever the caller asked hidraw for through
HIDIOCGFEATURE or HIDIOCGINPUT. A response larger than that overflows buf
with device-controlled content.
The intel-q
eventfs: Initialize ei->children and ei->list in init_ei()
In the Linux kernel, the following vulnerability has been resolved:
eventfs: Initialize ei->children and ei->list in init_ei()
eventfs_create_dir() allocates the eventfs_inode and initializes it with
init_ei(). But this does not initialize the eventfs_inode list_heads. If
the eventfs_create_dir() fails due to memory pressure, it will call
free_ei() before it initialized the lists, and that checks to make sure
the eventfs_inode has no children. But because the list wasn't
initialized, it will give a false warning.
Fix it by moving the list initialization into init_ei().
[ Rewrote change log ]
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: validate dirty page table on log replay
Each DIR_PAGE_ENTRY ends in a page_lcns[] array whose length is the on-disk
lcns_follow field. check_rstbl() validates the table bookkeeping but never
checks that this array fits in the entry, so a crafted lcns_follow lets the
v0->v1 conversion memmove and later replay passes run off the entry.
Add check_dp_table() to reject, right after check_rstbl(), any entry larger
than its size claims via struct_size() (the same expression used to allocate
these entries, so the check is overflow-safe by construction). All consumers
can
fs/ntfs3: fix info-leak on partial LZNT decompress in ni_read_frame()
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: fix info-leak on partial LZNT decompress in ni_read_frame()
ni_read_frame() decompresses an LZNT $DATA frame into the vmapped target
pages and then trusts decompress_lznt()'s return value:
unc_size = decompress_lznt(frame_ondisk, ondisk_size, frame_mem,
frame_size);
if ((ssize_t)unc_size < 0) err = unc_size;
else if (!unc_size || unc_size > frame_size) err = -EINVAL;
decompress_lznt() stops as soon as the compressed stream is exhausted
(e.g. a zero chunk header) and returns the number of bytes it actually
wrote, which m
fs/ntfs3: bound page_lcns[] index by the log record
In the Linux kernel, the following vulnerability has been resolved:
fs/ntfs3: bound page_lcns[] index by the log record
The copy_lcns loop and the redo shorten loop index page_lcns[] at j + i,
where i runs up to the log record's lcns_follow. That count is checked only
against the record's own length, not the target entry, so check_dp_table()
(which validates the entry's lcns_follow) does not cover it: the copy_lcns
entry may even be freshly allocated after that check, and find_dp() bounds j
but not i. A crafted record thus overflows page_lcns[] of an otherwise valid
entry.
Add dp_range_ok() and reject, before each loop, any record whose ru
ecryptfs: hold msg ctx list lock when cleaning daemon queue
In the Linux kernel, the following vulnerability has been resolved:
ecryptfs: hold msg ctx list lock when cleaning daemon queue
ecryptfs_exorcise_daemon() drops queued messages from a dying daemon
without holding ecryptfs_msg_ctx_lists_mux, but
ecryptfs_msg_ctx_alloc_to_free() requires that lock.
Take the list lock while moving the queued contexts back to the free
list to avoid racing with other global msg ctx list users.
In the Linux kernel, the following vulnerability has been resolved:
ecryptfs: pass packet set buffer size to parser
ecryptfs_parse_packet_set() receives a pointer into the file header, but
it calculates the remaining packet buffer size from PAGE_SIZE - 8. For
version 1 headers the packet set starts later in the header, so this can
overstate the available buffer.
Pass the actual packet set buffer length from the caller and calculate
per-packet limits from the remaining bytes in that buffer. Recompute the
remaining length after consuming a tag 3 packet before parsing the
following tag 11 packet.