Уязвимости linux-lts-xenial · Страница 175

extcon: Modify extcon device to be created after driver data is set

In the Linux kernel, the following vulnerability has been resolved: extcon: Modify extcon device to be created after driver data is set Currently, someone can invoke the sysfs such as state_show() intermittently before dev_set_drvdata() is done. And it can be a cause of kernel Oops because of edev is Null at that time. So modified the driver registration to after setting drviver data. - Oops's backtrace. Backtrace: [<c067865c>] (state_show) from [<c05222e8>] (dev_attr_show) [<c05222c0>] (dev_attr_show) from [<c02c66e0>] (sysfs_kf_seq_show) [<c02c6648>] (sysfs_kf_seq_show) from [<c02c496c>] (kernfs_seq_show) [<c02c4938>] (kernfs_seq_show)

tty: synclink_gt: Fix null-pointer-dereference in slgt_clean()

In the Linux kernel, the following vulnerability has been resolved: tty: synclink_gt: Fix null-pointer-dereference in slgt_clean() When the driver fails at alloc_hdlcdev(), and then we remove the driver module, we will get the following splat: [ 25.065966] general protection fault, probably for non-canonical address 0xdffffc0000000182: 0000 [#1] PREEMPT SMP KASAN PTI [ 25.066914] KASAN: null-ptr-deref in range [0x0000000000000c10-0x0000000000000c17] [ 25.069262] RIP: 0010:detach_hdlc_protocol+0x2a/0x3e0 [ 25.077709] Call Trace: [ 25.077924] <TASK> [ 25.078108] unregister_hdlc_device+0x16/0x30 [ 25.078481] slgt_cleanup+0x15

drivers: staging: rtl8192u: Fix deadlock in ieee80211_beacons_stop()

In the Linux kernel, the following vulnerability has been resolved: drivers: staging: rtl8192u: Fix deadlock in ieee80211_beacons_stop() There is a deadlock in ieee80211_beacons_stop(), which is shown below: (Thread 1) | (Thread 2) | ieee80211_send_beacon() ieee80211_beacons_stop() | mod_timer() spin_lock_irqsave() //(1) | (wait a time) ... | ieee80211_send_beacon_cb() del_timer_sync() | spin_lock_irqsave() //(2) (wait timer to stop) | ... We hold ieee->beacon_lock in position (1) of thread 1 and use del_timer_sync() to wait timer to stop, but ti

drivers: tty: serial: Fix deadlock in sa1100_set_termios()

In the Linux kernel, the following vulnerability has been resolved: drivers: tty: serial: Fix deadlock in sa1100_set_termios() There is a deadlock in sa1100_set_termios(), which is shown below: (Thread 1) | (Thread 2) | sa1100_enable_ms() sa1100_set_termios() | mod_timer() spin_lock_irqsave() //(1) | (wait a time) ... | sa1100_timeout() del_timer_sync() | spin_lock_irqsave() //(2) (wait timer to stop) | ... We hold sport->port.lock in position (1) of thread 1 and use del_timer_sync() to wait timer to stop, but timer handler also need sport->p

USB: host: isp116x: check return value after calling platform_get_resource()

In the Linux kernel, the following vulnerability has been resolved: USB: host: isp116x: check return value after calling platform_get_resource() It will cause null-ptr-deref if platform_get_resource() returns NULL, we need check the return value.

staging: rtl8712: fix uninit-value in usb_read8() and friends

In the Linux kernel, the following vulnerability has been resolved: staging: rtl8712: fix uninit-value in usb_read8() and friends When r8712_usbctrl_vendorreq() returns negative, 'data' in usb_read{8,16,32} will not be initialized. BUG: KMSAN: uninit-value in string_nocheck lib/vsprintf.c:643 [inline] BUG: KMSAN: uninit-value in string+0x4ec/0x6f0 lib/vsprintf.c:725 string_nocheck lib/vsprintf.c:643 [inline] string+0x4ec/0x6f0 lib/vsprintf.c:725 vsnprintf+0x2222/0x3650 lib/vsprintf.c:2806 va_format lib/vsprintf.c:1704 [inline] pointer+0x18e6/0x1f70 lib/vsprintf.c:2443 vsnprintf+0x1a9b/0x3650 lib/vsprintf.c:2810 vprintk_store+0x537/0

staging: rtl8712: fix uninit-value in r871xu_drv_init()

In the Linux kernel, the following vulnerability has been resolved: staging: rtl8712: fix uninit-value in r871xu_drv_init() When 'tmpU1b' returns from r8712_read8(padapter, EE_9346CR) is 0, 'mac[6]' will not be initialized. BUG: KMSAN: uninit-value in r871xu_drv_init+0x2d54/0x3070 drivers/staging/rtl8712/usb_intf.c:541 r871xu_drv_init+0x2d54/0x3070 drivers/staging/rtl8712/usb_intf.c:541 usb_probe_interface+0xf19/0x1600 drivers/usb/core/driver.c:396 really_probe+0x653/0x14b0 drivers/base/dd.c:596 __driver_probe_device+0x3e9/0x530 drivers/base/dd.c:752 driver_probe_device drivers/base/dd.c:782 [inline] __device_attach_driver+0x79f/0x11

netfilter: nf_tables: initialize registers in nft_do_chain()

In the Linux kernel, the following vulnerability has been resolved: netfilter: nf_tables: initialize registers in nft_do_chain() Initialize registers to avoid stack leak into userspace.

• Обновитесь до 4.4.0-239.273~14.04.1

ALSA: oss: Fix PCM OSS buffer allocation overflow

In the Linux kernel, the following vulnerability has been resolved: ALSA: oss: Fix PCM OSS buffer allocation overflow We've got syzbot reports hitting INT_MAX overflow at vmalloc() allocation that is called from snd_pcm_plug_alloc(). Although we apply the restrictions to input parameters, it's based only on the hw_params of the underlying PCM device. Since the PCM OSS layer allocates a temporary buffer for the data conversion, the size may become unexpectedly large when more channels or higher rates is given; in the reported case, it went over INT_MAX, hence it hits WARN_ON(). This patch is an attempt to avoid such an overflow and an all

ALSA: pcm: Fix races among concurrent hw_params and hw_free calls

In the Linux kernel, the following vulnerability has been resolved: ALSA: pcm: Fix races among concurrent hw_params and hw_free calls Currently we have neither proper check nor protection against the concurrent calls of PCM hw_params and hw_free ioctls, which may result in a UAF. Since the existing PCM stream lock can't be used for protecting the whole ioctl operations, we need a new mutex to protect those racy calls. This patch introduced a new mutex, runtime->buffer_mutex, and applies it to both hw_params and hw_free ioctl code paths. Along with it, the both functions are slightly modified (the mmap_count check is moved into the state-

mac80211: fix potential double free on mesh join

In the Linux kernel, the following vulnerability has been resolved: mac80211: fix potential double free on mesh join While commit 6a01afcf8468 ("mac80211: mesh: Free ie data when leaving mesh") fixed a memory leak on mesh leave / teardown it introduced a potential memory corruption caused by a double free when rejoining the mesh: ieee80211_leave_mesh() -> kfree(sdata->u.mesh.ie); ... ieee80211_join_mesh() -> copy_mesh_setup() -> old_ie = ifmsh->ie; -> kfree(old_ie); This double free / kernel panics can be reproduced by using wpa_supplicant with an encrypted mesh (if set up without encryption via "iw" then ifmsh->ie is

uaccess: fix integer overflow on access_ok()

In the Linux kernel, the following vulnerability has been resolved: uaccess: fix integer overflow on access_ok() Three architectures check the end of a user access against the address limit without taking a possible overflow into account. Passing a negative length or another overflow in here returns success when it should not. Use the most common correct implementation here, which optimizes for a constant 'size' argument, and turns the common case into a single comparison.

ALSA: pcm: Fix races among concurrent prealloc proc writes

In the Linux kernel, the following vulnerability has been resolved: ALSA: pcm: Fix races among concurrent prealloc proc writes We have no protection against concurrent PCM buffer preallocation changes via proc files, and it may potentially lead to UAF or some weird problem. This patch applies the PCM open_mutex to the proc write operation for avoiding the racy proc writes and the PCM stream open (and further operations).

iio: accel: mma8452: use the correct logic to get mma8452_data

In the Linux kernel, the following vulnerability has been resolved: iio: accel: mma8452: use the correct logic to get mma8452_data The original logic to get mma8452_data is wrong, the *dev point to the device belong to iio_dev. we can't use this dev to find the correct i2c_client. The original logic happen to work because it finally use dev->driver_data to get iio_dev. Here use the API to_i2c_client() is wrong and make reader confuse. To correct the logic, it should be like this struct mma8452_data *data = iio_priv(dev_get_drvdata(dev)); But after commit 8b7651f25962 ("iio: iio_device_alloc(): Remove unnecessary self drvdata"), the uppe

jffs2: fix memory leak in jffs2_do_mount_fs

In the Linux kernel, the following vulnerability has been resolved: jffs2: fix memory leak in jffs2_do_mount_fs If jffs2_build_filesystem() in jffs2_do_mount_fs() returns an error, we can observe the following kmemleak report: -------------------------------------------- unreferenced object 0xffff88811b25a640 (size 64): comm "mount", pid 691, jiffies 4294957728 (age 71.952s) hex dump (first 32 bytes): 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................ 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................ backtrace: [<ffffffffa493be24>] kmem_cache_alloc_trace+0x584/0x880 [<ffffffffa5423a06>]

jffs2: fix memory leak in jffs2_scan_medium

In the Linux kernel, the following vulnerability has been resolved: jffs2: fix memory leak in jffs2_scan_medium If an error is returned in jffs2_scan_eraseblock() and some memory has been added to the jffs2_summary *s, we can observe the following kmemleak report: -------------------------------------------- unreferenced object 0xffff88812b889c40 (size 64): comm "mount", pid 692, jiffies 4294838325 (age 34.288s) hex dump (first 32 bytes): 40 48 b5 14 81 88 ff ff 01 e0 31 00 00 00 50 00 @H........1...P. 00 00 01 00 00 00 01 00 00 00 02 00 00 00 09 08 ................ backtrace: [<ffffffffae93a3a3>] __kmalloc+0x613/0x910

can: m_can: m_can_tx_handler(): fix use after free of skb

In the Linux kernel, the following vulnerability has been resolved: can: m_can: m_can_tx_handler(): fix use after free of skb can_put_echo_skb() will clone skb then free the skb. Move the can_put_echo_skb() for the m_can version 3.0.x directly before the start of the xmit in hardware, similar to the 3.1.x branch.

exec: Force single empty string when argv is empty

In the Linux kernel, the following vulnerability has been resolved: exec: Force single empty string when argv is empty Quoting[1] Ariadne Conill: "In several other operating systems, it is a hard requirement that the second argument to execve(2) be the name of a program, thus prohibiting a scenario where argc < 1. POSIX 2017 also recommends this behaviour, but it is not an explicit requirement[2]: The argument arg0 should point to a filename string that is associated with the process being started by one of the exec functions. ... Interestingly, Michael Kerrisk opened an issue about this in 2008[3], but there was no consensus

media: usb: go7007: s2250-board: fix leak in probe()

In the Linux kernel, the following vulnerability has been resolved: media: usb: go7007: s2250-board: fix leak in probe() Call i2c_unregister_device(audio) on this error path.

ALSA: firewire-lib: fix uninitialized flag for AV/C deferred transaction

In the Linux kernel, the following vulnerability has been resolved: ALSA: firewire-lib: fix uninitialized flag for AV/C deferred transaction AV/C deferred transaction was supported at a commit 00a7bb81c20f ("ALSA: firewire-lib: Add support for deferred transaction") while 'deferrable' flag can be uninitialized for non-control/notify AV/C transactions. UBSAN reports it: kernel: ================================================================================ kernel: UBSAN: invalid-load in /build/linux-aa0B4d/linux-5.15.0/sound/firewire/fcp.c:363:9 kernel: load of value 158 is not a valid value for type '_Bool' kernel: CPU: 3 PID: 182227 Comm