PatchFirst · Свежие уязвимости
За последние 30 дней в linux опубликовано уязвимостей: 206; в каталоге KEV: 0.
Уязвимостей: 4192
In the Linux kernel, the following vulnerability has been resolved: jfs: Fix shift-out-of-bounds in dbDiscardAG When searching for the next smaller log2 block, BLKSTOL2() returned 0, causing shift exponent -1 to be negative. This patch fixes the issue by exiting the loop directly when negative shift is found.
Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority.
In the Linux kernel, the following vulnerability has been resolved: md/raid5: avoid BUG_ON() while continue reshape after reassembling Currently, mdadm support --revert-reshape to abort the reshape while reassembling, as the test 07revert-grow. However, following BUG_ON() can be triggerred by the test: kernel BUG at drivers/md/raid5.c:6278! invalid opcode: 0000 [#1] PREEMPT SMP PTI irq event stamp: 158985 CPU: 6 PID: 891 Comm: md0_reshape Not tainted 6.9.0-03335-g7592a0b0049a #94 RIP: 0010:reshape_request+0x3f1/0xe60 Call Trace: <TASK> raid5_sync_request+0x43d/0x550 md_do_sync+0xb7a/0x2110 md_thread+0x294/0x2b0 kthread+0x147/0x1c0 re
In the Linux kernel, the following vulnerability has been resolved: media: xc2028: avoid use-after-free in load_firmware_cb() syzkaller reported use-after-free in load_firmware_cb() [1]. The reason is because the module allocated a struct tuner in tuner_probe(), and then the module initialization failed, the struct tuner was released. A worker which created during module initialization accesses this struct tuner later, it caused use-after-free. The process is as follows: task-6504 worker_thread tuner_probe <= alloc dvb_frontend [2] ... request_firmware_nowait <= create a worker ... tun
In the Linux kernel, the following vulnerability has been resolved: serial: core: check uartclk for zero to avoid divide by zero Calling ioctl TIOCSSERIAL with an invalid baud_base can result in uartclk being zero, which will result in a divide by zero error in uart_get_divisor(). The check for uartclk being zero in uart_set_info() needs to be done before other settings are made as subsequent calls to ioctl TIOCSSERIAL for the same port would be impacted if the uartclk check was done where uartclk gets set. Oops: divide error: 0000 PREEMPT SMP KASAN PTI RIP: 0010:uart_get_divisor (drivers/tty/serial/serial_core.c:580) Call Trace: <TASK>
In the Linux kernel, the following vulnerability has been resolved: usb: vhci-hcd: Do not drop references before new references are gained At a few places the driver carries stale pointers to references that can still be used. Make sure that does not happen. This strictly speaking closes ZDI-CAN-22273, though there may be similar races in the driver.
Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority.
In the Linux kernel, the following vulnerability has been resolved: CDC-NCM: avoid overflow in sanity checking A broken device may give an extreme offset like 0xFFF0 and a reasonable length for a fragment. In the sanity check as formulated now, this will create an integer overflow, defeating the sanity check. Both offset and offset + len need to be checked in such a manner that no overflow can occur. And those quantities should be unsigned.
In the Linux kernel, the following vulnerability has been resolved: configfs: fix a race in configfs_{,un}register_subsystem() When configfs_register_subsystem() or configfs_unregister_subsystem() is executing link_group() or unlink_group(), it is possible that two processes add or delete list concurrently. Some unfortunate interleavings of them can cause kernel panic. One of cases is: A --> B --> C --> D A <-- B <-- C <-- D delete list_head *B | delete list_head *C --------------------------------|----------------------------------- configfs_unregister_subsystem | configfs_unregister_subsystem unlink_group
In the Linux kernel, the following vulnerability has been resolved: RDMA/ib_srp: Fix a deadlock Remove the flush_workqueue(system_long_wq) call since flushing system_long_wq is deadlock-prone and since that call is redundant with a preceding cancel_work_sync()
In the Linux kernel, the following vulnerability has been resolved: KVM: x86/mmu: make apf token non-zero to fix bug In current async pagefault logic, when a page is ready, KVM relies on kvm_arch_can_dequeue_async_page_present() to determine whether to deliver a READY event to the Guest. This function test token value of struct kvm_vcpu_pv_apf_data, which must be reset to zero by Guest kernel when a READY event is finished by Guest. If value is zero meaning that a READY event is done, so the KVM can deliver another. But the kvm_arch_setup_async_pf() may produce a valid token with zero value, which is confused with previous mention and may l
Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority.
In the Linux kernel, the following vulnerability has been resolved: netfilter: nf_queue: fix possible use-after-free Eric Dumazet says: The sock_hold() side seems suspect, because there is no guarantee that sk_refcnt is not already 0. On failure, we cannot queue the packet and need to indicate an error. The packet will be dropped by the caller. v2: split skb prefetch hunk into separate change
In the Linux kernel, the following vulnerability has been resolved: btrfs: do not start relocation until in progress drops are done We hit a bug with a recovering relocation on mount for one of our file systems in production. I reproduced this locally by injecting errors into snapshot delete with balance running at the same time. This presented as an error while looking up an extent item WARNING: CPU: 5 PID: 1501 at fs/btrfs/extent-tree.c:866 lookup_inline_extent_backref+0x647/0x680 CPU: 5 PID: 1501 Comm: btrfs-balance Not tainted 5.16.0-rc8+ #8 RIP: 0010:lookup_inline_extent_backref+0x647/0x680 RSP: 0018:ffffae0a023ab960 EFLAGS:
Rejected reason: This CVE ID has been rejected or withdrawn by its CVE Numbering Authority.
In the Linux kernel, the following vulnerability has been resolved: nfc: pn533: Wait for out_urb's completion in pn533_usb_send_frame() Fix a use-after-free that occurs in hcd when in_urb sent from pn533_usb_send_frame() is completed earlier than out_urb. Its callback frees the skb data in pn533_send_async_complete() that is used as a transfer buffer of out_urb. Wait before sending in_urb until the callback of out_urb is called. To modify the callback of out_urb alone, separate the complete function of out_urb and ack_urb. Found by a modified version of syzkaller. BUG: KASAN: use-after-free in dummy_timer Call Trace: memcpy (mm/kasan/sha
In the Linux kernel, the following vulnerability has been resolved: nilfs2: fix general protection fault in nilfs_btree_insert() If nilfs2 reads a corrupted disk image and tries to reads a b-tree node block by calling __nilfs_btree_get_block() against an invalid virtual block address, it returns -ENOENT because conversion of the virtual block address to a disk block address fails. However, this return value is the same as the internal code that b-tree lookup routines return to indicate that the block being searched does not exist, so functions that operate on that b-tree may misbehave. When nilfs_btree_insert() receives this spurious 'not
In the Linux kernel, the following vulnerability has been resolved: gsmi: fix null-deref in gsmi_get_variable We can get EFI variables without fetching the attribute, so we must allow for that in gsmi. commit 859748255b43 ("efi: pstore: Omit efivars caching EFI varstore access layer") added a new get_variable call with attr=NULL, which triggers panic in gsmi.
In the Linux kernel, the following vulnerability has been resolved: wifi: mac80211: sdata can be NULL during AMPDU start ieee80211_tx_ba_session_handle_start() may get NULL for sdata when a deauthentication is ongoing. Here a trace triggering the race with the hostapd test multi_ap_fronthaul_on_ap: (gdb) list *drv_ampdu_action+0x46 0x8b16 is in drv_ampdu_action (net/mac80211/driver-ops.c:396). 391 int ret = -EOPNOTSUPP; 392 393 might_sleep(); 394 395 sdata = get_bss_sdata(sdata); 396 if (!check_sdata_in_driver(sdata)) 397 return -EIO; 398 399 trace_drv_ampdu_a
In the Linux kernel, the following vulnerability has been resolved: exec: Fix ToCToU between perm check and set-uid/gid usage When opening a file for exec via do_filp_open(), permission checking is done against the file's metadata at that moment, and on success, a file pointer is passed back. Much later in the execve() code path, the file metadata (specifically mode, uid, and gid) is used to determine if/how to set the uid and gid. However, those values may have changed since the permissions check, meaning the execution may gain unintended privileges. For example, if a file could change permissions from executable and not set-id: --------
Сопоставьте установленный стек и версии со свежими базами уязвимостей.