Уязвимости linux-raspi-5.4 · Страница 194

serial: arc_uart: fix of_iomap leak in `arc_serial_probe`

In the Linux kernel, the following vulnerability has been resolved: serial: arc_uart: fix of_iomap leak in `arc_serial_probe` Smatch reports: drivers/tty/serial/arc_uart.c:631 arc_serial_probe() warn: 'port->membase' from of_iomap() not released on lines: 631. In arc_serial_probe(), if uart_add_one_port() fails, port->membase is not released, which would cause a resource leak. To fix this, I replace of_iomap with devm_platform_ioremap_resource.

• Обновитесь до 5.4.0-1093.104~18.04.1

ring-buffer: Do not swap cpu_buffer during resize process

In the Linux kernel, the following vulnerability has been resolved: ring-buffer: Do not swap cpu_buffer during resize process When ring_buffer_swap_cpu was called during resize process, the cpu buffer was swapped in the middle, resulting in incorrect state. Continuing to run in the wrong state will result in oops. This issue can be easily reproduced using the following two scripts: /tmp # cat test1.sh //#! /bin/sh for i in `seq 0 100000` do echo 2000 > /sys/kernel/debug/tracing/buffer_size_kb sleep 0.5 echo 5000 > /sys/kernel/debug/tracing/buffer_size_kb sleep 0.5 done /tmp # cat test2.sh //#! /bin/sh fo

wifi: ath9k: Fix potential stack-out-of-bounds write in ath9k_wmi_rsp_callback()

In the Linux kernel, the following vulnerability has been resolved: wifi: ath9k: Fix potential stack-out-of-bounds write in ath9k_wmi_rsp_callback() Fix a stack-out-of-bounds write that occurs in a WMI response callback function that is called after a timeout occurs in ath9k_wmi_cmd(). The callback writes to wmi->cmd_rsp_buf, a stack-allocated buffer that could no longer be valid when a timeout occurs. Set wmi->last_seq_id to 0 when a timeout occurred. Found by a modified version of syzkaller. BUG: KASAN: stack-out-of-bounds in ath9k_wmi_ctrl_rx Write of size 4 Call Trace: memcpy ath9k_wmi_ctrl_rx ath9k_htc_rx_msg ath9k_hif_usb_reg_in

• Обновитесь до 5.4.0-1088.99~18.04.1

wifi: brcmfmac: cfg80211: Pass the PMK in binary instead of hex

In the Linux kernel, the following vulnerability has been resolved: wifi: brcmfmac: cfg80211: Pass the PMK in binary instead of hex Apparently the hex passphrase mechanism does not work on newer chips/firmware (e.g. BCM4387). It seems there was a simple way of passing it in binary all along, so use that and avoid the hexification. OpenBSD has been doing it like this from the beginning, so this should work on all chips. Also clear the structure before setting the PMK. This was leaking uninitialized stack contents to the device.

• Обновитесь до 5.4.0-1093.104~18.04.1

ARM: 9317/1: kexec: Make smp stop calls asynchronous

In the Linux kernel, the following vulnerability has been resolved: ARM: 9317/1: kexec: Make smp stop calls asynchronous If a panic is triggered by a hrtimer interrupt all online cpus will be notified and set offline. But as highlighted by commit 19dbdcb8039c ("smp: Warn on function calls from softirq context") this call should not be made synchronous with disabled interrupts: softdog: Initiating panic Kernel panic - not syncing: Software Watchdog Timer expired WARNING: CPU: 1 PID: 0 at kernel/smp.c:753 smp_call_function_many_cond unwind_backtrace: show_stack dump_stack_lvl __warn warn_slowpath_fmt smp_call_f

drm/amdgpu: Fix integer overflow in amdgpu_cs_pass1

In the Linux kernel, the following vulnerability has been resolved: drm/amdgpu: Fix integer overflow in amdgpu_cs_pass1 The type of size is unsigned int, if size is 0x40000000, there will be an integer overflow, size will be zero after size *= sizeof(uint32_t), will cause uninitialized memory to be referenced later.

ipv6: Fix out-of-bounds access in ipv6_find_tlv()

In the Linux kernel, the following vulnerability has been resolved: ipv6: Fix out-of-bounds access in ipv6_find_tlv() optlen is fetched without checking whether there is more than one byte to parse. It can lead to out-of-bounds access. Found by InfoTeCS on behalf of Linux Verification Center (linuxtesting.org) with SVACE.

• Обновитесь до 5.4.0-1093.104~18.04.1

riscv: move memblock_allow_resize() after linear mapping is ready

In the Linux kernel, the following vulnerability has been resolved: riscv: move memblock_allow_resize() after linear mapping is ready The initial memblock metadata is accessed from kernel image mapping. The regions arrays need to "reallocated" from memblock and accessed through linear mapping to cover more memblock regions. So the resizing should not be allowed until linear mapping is ready. Note that there are memblock allocations when building linear mapping. This patch is similar to 24cc61d8cb5a ("arm64: memblock: don't permit memblock resizing until linear mapping is up"). In following log, many memblock regions are reserved before cr

scsi: qla2xxx: Fix memory leak in qla2x00_probe_one()

In the Linux kernel, the following vulnerability has been resolved: scsi: qla2xxx: Fix memory leak in qla2x00_probe_one() There is a memory leak reported by kmemleak: unreferenced object 0xffffc900003f0000 (size 12288): comm "modprobe", pid 19117, jiffies 4299751452 (age 42490.264s) hex dump (first 32 bytes): 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................ 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 ................ backtrace: [<00000000629261a8>] __vmalloc_node_range+0xe56/0x1110 [<0000000001906886>] __vmalloc_node+0xbd/0x150 [<000000005bb4dc34>] vmalloc+0x25/0x30 [<

udf: Detect system inodes linked into directory hierarchy

In the Linux kernel, the following vulnerability has been resolved: udf: Detect system inodes linked into directory hierarchy When UDF filesystem is corrupted, hidden system inodes can be linked into directory hierarchy which is an avenue for further serious corruption of the filesystem and kernel confusion as noticed by syzbot fuzzed images. Refuse to access system inodes linked into directory hierarchy and vice versa.

• Обновитесь до 5.4.0-1088.99~18.04.1

ext4: fix use-after-free read in ext4_find_extent for bigalloc + inline

In the Linux kernel, the following vulnerability has been resolved: ext4: fix use-after-free read in ext4_find_extent for bigalloc + inline Syzbot found the following issue: loop0: detected capacity change from 0 to 2048 EXT4-fs (loop0): mounted filesystem 00000000-0000-0000-0000-000000000000 without journal. Quota mode: none. ================================================================== BUG: KASAN: use-after-free in ext4_ext_binsearch_idx fs/ext4/extents.c:768 [inline] BUG: KASAN: use-after-free in ext4_find_extent+0x76e/0xd90 fs/ext4/extents.c:931 Read of size 4 at addr ffff888073644750 by task syz-executor420/5067 CPU: 0 PID: 5067

• Обновитесь до 5.4.0-1093.104~18.04.1

blk-throttle: prevent overflow while calculating wait time

In the Linux kernel, the following vulnerability has been resolved: blk-throttle: prevent overflow while calculating wait time There is a problem found by code review in tg_with_in_bps_limit() that 'bps_limit * jiffy_elapsed_rnd' might overflow. Fix the problem by calling mul_u64_u64_div_u64() instead.

tpm: acpi: Call acpi_put_table() to fix memory leak

In the Linux kernel, the following vulnerability has been resolved: tpm: acpi: Call acpi_put_table() to fix memory leak The start and length of the event log area are obtained from TPM2 or TCPA table, so we call acpi_get_table() to get the ACPI information, but the acpi_get_table() should be coupled with acpi_put_table() to release the ACPI memory, add the acpi_put_table() properly to fix the memory leak. While we are at it, remove the redundant empty line at the end of the tpm_read_log_acpi().

drm/meson: explicitly remove aggregate driver at module unload time

In the Linux kernel, the following vulnerability has been resolved: drm/meson: explicitly remove aggregate driver at module unload time Because component_master_del wasn't being called when unloading the meson_drm module, the aggregate device would linger forever in the global aggregate_devices list. That means when unloading and reloading the meson_dw_hdmi module, component_add would call into try_to_bring_up_aggregate_device and find the unbound meson_drm aggregate device. This would in turn dereference some of the aggregate_device's struct entries which point to memory automatically freed by the devres API when unbinding the aggregate d

drm: Fix potential null-ptr-deref due to drmm_mode_config_init()

In the Linux kernel, the following vulnerability has been resolved: drm: Fix potential null-ptr-deref due to drmm_mode_config_init() drmm_mode_config_init() will call drm_mode_create_standard_properties() and won't check the ret value. When drm_mode_create_standard_properties() failed due to alloc, property will be a NULL pointer and may causes the null-ptr-deref. Fix the null-ptr-deref by adding the ret value check. Found null-ptr-deref while testing insert module bochs: general protection fault, probably for non-canonical address 0xdffffc000000000c: 0000 [#1] SMP KASAN PTI KASAN: null-ptr-deref in range [0x0000000000000060-0x00000000

drm/gma500: Fix null dereference in hdmi teardown

In the Linux kernel, the following vulnerability has been resolved: drm/gma500: Fix null dereference in hdmi teardown pci_set_drvdata sets the value of pdev->driver_data to NULL, after which the driver_data obtained from the same dev is dereferenced in oaktrail_hdmi_i2c_exit, and the i2c_dev is extracted from it. To prevent this, swap these calls. Found by Linux Verification Center (linuxtesting.org) with Svacer.

mm/hugetlb: fix folio is still mapped when deleted

In the Linux kernel, the following vulnerability has been resolved: mm/hugetlb: fix folio is still mapped when deleted Migration may be raced with fallocating hole. remove_inode_single_folio will unmap the folio if the folio is still mapped. However, it's called without folio lock. If the folio is migrated and the mapped pte has been converted to migration entry, folio_mapped() returns false, and won't unmap it. Due to extra refcount held by remove_inode_single_folio, migration fails, restores migration entry to normal pte, and the folio is mapped again. As a result, we triggered BUG in filemap_unaccount_folio. The log is as follows:

net: mscc: ocelot: Fix use-after-free caused by cyclic delayed work

In the Linux kernel, the following vulnerability has been resolved: net: mscc: ocelot: Fix use-after-free caused by cyclic delayed work The origin code calls cancel_delayed_work() in ocelot_stats_deinit() to cancel the cyclic delayed work item ocelot->stats_work. However, cancel_delayed_work() may fail to cancel the work item if it is already executing. While destroy_workqueue() does wait for all pending work items in the work queue to complete before destroying the work queue, it cannot prevent the delayed work item from being rescheduled within the ocelot_check_stats_work() function. This limitation exists because the delayed work item is

scsi: mvsas: Fix use-after-free bugs in mvs_work_queue

In the Linux kernel, the following vulnerability has been resolved: scsi: mvsas: Fix use-after-free bugs in mvs_work_queue During the detaching of Marvell's SAS/SATA controller, the original code calls cancel_delayed_work() in mvs_free() to cancel the delayed work item mwq->work_q. However, if mwq->work_q is already running, the cancel_delayed_work() may fail to cancel it. This can lead to use-after-free scenarios where mvs_free() frees the mvs_info while mvs_work_queue() is still executing and attempts to access the already-freed mvs_info. A typical race condition is illustrated below: CPU 0 (remove) | CPU 1 (delayed work call

scsi: target: target_core_configfs: Add length check to avoid buffer overflow

In the Linux kernel, the following vulnerability has been resolved: scsi: target: target_core_configfs: Add length check to avoid buffer overflow A buffer overflow arises from the usage of snprintf to write into the buffer "buf" in target_lu_gp_members_show function located in /drivers/target/target_core_configfs.c. This buffer is allocated with size LU_GROUP_NAME_BUF (256 bytes). snprintf(...) formats multiple strings into buf with the HBA name (hba->hba_group.cg_item), a slash character, a devicename (dev-> dev_group.cg_item) and a newline character, the total formatted string length may exceed the buffer size of 256 bytes. Since snprin