Уязвимости linux-hwe-5.15 · Страница 78

smb: client: fix OOB read/write from unvalidated DataOffset in coalesce_t2()

In the Linux kernel, the following vulnerability has been resolved: smb: client: fix OOB read/write from unvalidated DataOffset in coalesce_t2() coalesce_t2() computes data pointers directly from server-supplied DataOffset fields with no validation against buffer bounds: data_area_of_tgt = (char *)&pSMBt->hdr.Protocol + get_unaligned_le16(&pSMBt->t2_rsp.DataOffset); data_area_of_src = (char *)&pSMBs->hdr.Protocol + get_unaligned_le16(&pSMBs->t2_rsp.DataOffset); data_area_of_tgt += total_in_tgt; ... memcpy(data_area_of_tgt, data_area_of_src, total_in_src); A small DataOffset can push a po

smb: client: fix use-before-check of ReparseDataLength in reparse_buf_ptr()

In the Linux kernel, the following vulnerability has been resolved: smb: client: fix use-before-check of ReparseDataLength in reparse_buf_ptr() reparse_buf_ptr() reads buf->ReparseDataLength before checking that count covers the full fixed header: buf = (struct reparse_data_buffer *)((u8 *)io + off); len = sizeof(*buf); /* 8 bytes */ rdlen = le16_to_cpu(buf->ReparseDataLength); /* offset 4, 2 bytes */ if (count < len || count < rdlen + len) /* check comes after */ struct reparse_data_buffer has ReparseDataLength at offset 4. If a server returns OutputCount < 6, the read at offset 4-5 reaches

smb: client: reject a tree connect response whose byte count is too small

In the Linux kernel, the following vulnerability has been resolved: smb: client: reject a tree connect response whose byte count is too small CIFSTCon() bounds its strnlen() over the byte area with the server's ByteCount minus two, which for ByteCount 0 or 1 goes negative as an int and converts to a huge size_t. The later subtraction wraps the __u16 bytes_left, and that is what bounds cifs_strndup_from_utf16(): a bound of up to 65535 against a ~16 KB cifs_req_poolp object runs off the end of the slab object, and the bytes reach userspace through tcon->nativeFileSystem in /proc/fs/cifs/DebugData. Reject a byte area too small for what the p

HID: picolcd: clamp eeprom debugfs read to bytes actually received

In the Linux kernel, the following vulnerability has been resolved: HID: picolcd: clamp eeprom debugfs read to bytes actually received picolcd_debug_eeprom_read() trusts resp->raw_data[2] -- a length byte supplied by the device in its REPORT_EE_DATA reply -- clamped only to the caller's read() count: ret = resp->raw_data[2]; if (ret > s) ret = s; if (copy_to_user(u, resp->raw_data+3, ret)) It never checks resp->raw_size, the number of bytes picolcd_raw_event() actually copied into the 64-byte raw_data[] of the kmalloc'd struct picolcd_pending. A device (or a spoofed picoLCD) returning a length byte of 0xff, read with a count >= 255,

• Обновитесь до 5.15.0-202.212~20.04.1

HID: roccat: free buffered reports when destroying device

In the Linux kernel, the following vulnerability has been resolved: HID: roccat: free buffered reports when destroying device roccat_report_event() duplicates each report with kmemdup() and stores the allocation in a circular-buffer slot. The allocation is released only when that slot is reused. The device destruction paths free struct roccat_device without releasing reports still stored in cbuf[]. This makes those allocations unreachable and leaks up to ROCCAT_CBUF_SIZE report buffers per device. Add a small destructor that frees every buffered report before freeing the device, and use it in both paths that can destroy a registered devic

• Обновитесь до 5.15.0-202.212~20.04.1

HID: sensor: custom: Fix field sysfs group cleanup on failure

In the Linux kernel, the following vulnerability has been resolved: HID: sensor: custom: Fix field sysfs group cleanup on failure hid_sensor_custom_add_attributes() creates one sysfs group for each custom sensor field. If sysfs_create_group() fails after some groups have already been created, the function returns the error without removing the previously created groups. Add a local unwind path to remove the groups that were already created. With enable_sensor exposed only after the field attributes are ready, this path can free sensor_inst->fields without leaving enable_sensor able to access pointers into that array.

• Обновитесь до 5.15.0-202.212~20.04.1

HID: sony: fix UAF of ghl_poke_timer / ghl_urb at driver unbind

In the Linux kernel, the following vulnerability has been resolved: HID: sony: fix UAF of ghl_poke_timer / ghl_urb at driver unbind For GHL (Guitar Hero Live) dongles, sony_probe() arms a periodic timer: ghl_magic_poke() (the timer callback) submits sc->ghl_urb, and the URB completion ghl_magic_poke_cb() re-arms the timer with mod_timer(). sony_remove() drained the timer with timer_delete_sync() and then freed the URB with usb_free_urb(): timer_delete_sync(&sc->ghl_poke_timer); usb_free_urb(sc->ghl_urb); timer_delete_sync() does not block re-arming, and while the URB is in flight the timer is not pending, so the sync delete is a no-op.

HID: mcp2221: stop device IO before hid_hw_stop

In the Linux kernel, the following vulnerability has been resolved: HID: mcp2221: stop device IO before hid_hw_stop Quiesce device IO at the start of the devm cleanup callback mcp2221_hid_unregister() so that incoming HID reports cannot race with hardware teardown during probe failure or device removal, addressing a potential use-after-free. Guard the call to hid_device_io_stop() with io_started. On normal removal hid_device_remove() has already cleared io_started before the devres group is released, so an unconditional call would otherwise hit the !io_started path and emit a spurious "io already stopped" warning on every removal. The guar

HID: mcp2221: clear rxbuf after I2C/SMBus transfer completes

In the Linux kernel, the following vulnerability has been resolved: HID: mcp2221: clear rxbuf after I2C/SMBus transfer completes mcp_i2c_smbus_read() stores the caller-supplied buffer pointer in mcp->rxbuf for the duration of a transfer but never clears it when the transfer finishes or times out. Once the caller frees or reuses the buffer, mcp->rxbuf becomes a dangling pointer. A delayed or spurious MCP2221_I2C_GET_DATA report can then drive mcp2221_raw_event() to memcpy device data into the freed memory, causing a write use-after-free. Route all return paths through a single exit point that clears mcp->rxbuf and mcp->rxbuf_size, so that t

HID: mcp2221: validate report size in mcp2221_raw_event()

In the Linux kernel, the following vulnerability has been resolved: HID: mcp2221: validate report size in mcp2221_raw_event() mcp2221_raw_event() never validates the size of incoming HID reports. In the MCP2221_I2C_GET_DATA path it trusts the device-supplied data[3] as the copy length without checking that 4 + data[3] bytes actually exist in the received report. A malicious or misbehaving USB device can send a short report with a large data[3], causing the memcpy to read past the valid report data in the HID transfer buffer and leak uninitialized kernel memory back to userspace through the I2C/SMBus read path. Add a minimum size check at e

• Обновитесь до 5.15.0-202.212~20.04.1

fs/ntfs3: validate dirty page table on log replay

In the Linux kernel, the following vulnerability has been resolved: fs/ntfs3: validate dirty page table on log replay Each DIR_PAGE_ENTRY ends in a page_lcns[] array whose length is the on-disk lcns_follow field. check_rstbl() validates the table bookkeeping but never checks that this array fits in the entry, so a crafted lcns_follow lets the v0->v1 conversion memmove and later replay passes run off the entry. Add check_dp_table() to reject, right after check_rstbl(), any entry larger than its size claims via struct_size() (the same expression used to allocate these entries, so the check is overflow-safe by construction). All consumers can

• Обновитесь до 5.15.0-202.212~20.04.1

fs/ntfs3: fix info-leak on partial LZNT decompress in ni_read_frame()

In the Linux kernel, the following vulnerability has been resolved: fs/ntfs3: fix info-leak on partial LZNT decompress in ni_read_frame() ni_read_frame() decompresses an LZNT $DATA frame into the vmapped target pages and then trusts decompress_lznt()'s return value: unc_size = decompress_lznt(frame_ondisk, ondisk_size, frame_mem, frame_size); if ((ssize_t)unc_size < 0) err = unc_size; else if (!unc_size || unc_size > frame_size) err = -EINVAL; decompress_lznt() stops as soon as the compressed stream is exhausted (e.g. a zero chunk header) and returns the number of bytes it actually wrote, which m

• Обновитесь до 5.15.0-202.212~20.04.1

fs/ntfs3: bound page_lcns[] index by the log record

In the Linux kernel, the following vulnerability has been resolved: fs/ntfs3: bound page_lcns[] index by the log record The copy_lcns loop and the redo shorten loop index page_lcns[] at j + i, where i runs up to the log record's lcns_follow. That count is checked only against the record's own length, not the target entry, so check_dp_table() (which validates the entry's lcns_follow) does not cover it: the copy_lcns entry may even be freshly allocated after that check, and find_dp() bounds j but not i. A crafted record thus overflows page_lcns[] of an otherwise valid entry. Add dp_range_ok() and reject, before each loop, any record whose ru

• Обновитесь до 5.15.0-202.212~20.04.1

ecryptfs: hold msg ctx list lock when cleaning daemon queue

In the Linux kernel, the following vulnerability has been resolved: ecryptfs: hold msg ctx list lock when cleaning daemon queue ecryptfs_exorcise_daemon() drops queued messages from a dying daemon without holding ecryptfs_msg_ctx_lists_mux, but ecryptfs_msg_ctx_alloc_to_free() requires that lock. Take the list lock while moving the queued contexts back to the free list to avoid racing with other global msg ctx list users.

• Обновитесь до 5.15.0-202.212~20.04.1

ecryptfs: pass packet set buffer size to parser

In the Linux kernel, the following vulnerability has been resolved: ecryptfs: pass packet set buffer size to parser ecryptfs_parse_packet_set() receives a pointer into the file header, but it calculates the remaining packet buffer size from PAGE_SIZE - 8. For version 1 headers the packet set starts later in the header, so this can overstate the available buffer. Pass the actual packet set buffer length from the caller and calculate per-packet limits from the remaining bytes in that buffer. Recompute the remaining length after consuming a tag 3 packet before parsing the following tag 11 packet.

• Обновитесь до 5.15.0-202.212~20.04.1

ecryptfs: reject oversized encrypted_key_size in parse_tag_3_packet

In the Linux kernel, the following vulnerability has been resolved: ecryptfs: reject oversized encrypted_key_size in parse_tag_3_packet parse_tag_3_packet() set encrypted_key_size from the Tag 3 packet body without bounding it against ECRYPTFS_MAX_KEY_BYTES (64). When encrypted_key_size > 64, decrypt_passphrase_encrypted_session_key() sets decrypted_key_size = encrypted_key_size and performs two out-of-bounds writes: 1. crypto_skcipher_decrypt() writes encrypted_key_size bytes into decrypted_key[64] via scatterlist, overflowing into the parent ecryptfs_auth_tok struct. 2. memcpy(crypt_stat->key, decrypted_key, decrypted_key_size) wri

• Обновитесь до 5.15.0-202.212~20.04.1

ecryptfs: reject too-small tag 70 packets

In the Linux kernel, the following vulnerability has been resolved: ecryptfs: reject too-small tag 70 packets ecryptfs_parse_tag_70_packet() subtracts fixed metadata fields from the parsed packet body size to derive the encrypted filename size. A malformed packet with a body smaller than those fixed fields can underflow that size calculation. Reject tag 70 packets before the subtraction unless the body contains the signature, cipher code, and at least one byte of encrypted filename data.

• Обновитесь до 5.15.0-202.212~20.04.1

ecryptfs: release message context on send failure

In the Linux kernel, the following vulnerability has been resolved: ecryptfs: release message context on send failure ecryptfs_send_message_locked() moves a message context from the free list to the allocated list before sending the request to the userspace daemon. If ecryptfs_send_miscdev() fails, the context is left on the allocated list and cannot be reused. Move it back to the free list on failure and clear the caller's pointer.

• Обновитесь до 5.15.0-202.212~20.04.1

ext2: Fix lost inode updates for IS_SYNC inodes

In the Linux kernel, the following vulnerability has been resolved: ext2: Fix lost inode updates for IS_SYNC inodes ext2_setsize() and ext2_xattr_set2() had a construct like: if (IS_SYNC(inode)) { sync_inode_metadata(inode, 1); } else { mark_inode_dirty(inode); } which leads to lost inode updates for IS_SYNC inodes because sync_inode_metadata() does anything only if the inode is already dirty and hence inode updates may be simply lost. Fix the problem by unconditionally marking the inode dirty and *then* call sync_inode_metadata().

fbdev: omapfb: panel-dsi-cm: initialize lock before registering display

In the Linux kernel, the following vulnerability has been resolved: fbdev: omapfb: panel-dsi-cm: initialize lock before registering display dsicm_probe() registers the display before initializing ddata->lock. Once omapdss_register_display() publishes the display, another consumer can reach a dsicm callback that takes this mutex while it is still uninitialized. Initialize the mutex before registering the display so the published callbacks always see a valid lock.

• Обновитесь до 5.15.0-202.212~20.04.1