PatchFirst · Свежие уязвимости
За последние 30 дней в linux-fips опубликовано уязвимостей: 376; в каталоге KEV: 0.
Уязвимостей: 5540
In the Linux kernel, the following vulnerability has been resolved: i2c: core: fix adapter deregistration race Adapters can be looked up by their id using i2c_get_adapter() which takes a reference to the embedded struct device. Remove the adapter from the IDR before tearing it down during deregistration (and on registration failure) to make sure its resources are not accessed after having been freed (e.g. the device name).
In the Linux kernel, the following vulnerability has been resolved: Input: elan_i2c - prevent division by zero and arithmetic underflow The Elan I2C touchpad driver queries the device for its physical dimensions and trace counts to calculate the device resolution and width. However, if the device firmware or device tree provides invalid zero values for x_traces or y_traces, it results in a fatal division-by-zero exception leading to a kernel panic during device probe. Add checks to ensure these parameters are non-zero before performing the division. If invalid trace values are detected, fall back to a safe default of 1. Additionally, prev
In the Linux kernel, the following vulnerability has been resolved: Input: goodix - clamp the device-reported contact count goodix_ts_read_input_report() copies the number of touch points reported by the device into an on-stack buffer u8 point_data[2 + GOODIX_MAX_CONTACT_SIZE * GOODIX_MAX_CONTACTS]; which is sized for at most GOODIX_MAX_CONTACTS (10) contacts. The only runtime check bounds the per-interrupt count against ts->max_touch_num, but that value is taken verbatim from a 4-bit field of the device configuration block and is never clamped: ts->max_touch_num = ts->config[MAX_CONTACTS_LOC] & 0x0f; The nibble can be 0..15, so a mal
In the Linux kernel, the following vulnerability has been resolved: Input: iforce - bound the device-reported force-feedback effect index iforce_process_packet() handles a status report (packet id 0x02) by taking a force-feedback effect index straight from the device wire and using it to address the per-effect state array: i = data[1] & 0x7f; if (data[1] & 0x80) { if (!test_and_set_bit(FF_CORE_IS_PLAYED, iforce->core_effects[i].flags)) ... } else if (test_and_clear_bit(FF_CORE_IS_PLAYED, iforce->core_effects[i].flags)) { ... } The index is masked only with 0x7f, so it ranges 0..127, but core_effects[] holds
In the Linux kernel, the following vulnerability has been resolved: Input: touchwin - reset the packet index on every complete packet tw_interrupt() accumulates each non-zero serial byte into a fixed three-byte buffer with a running index that is only reset once a full packet has been received *and* the device's two Y bytes agree: tw->data[tw->idx++] = data; if (tw->idx == TW_LENGTH && tw->data[1] == tw->data[2]) { ... tw->idx = 0; } The reset is gated on tw->data[1] == tw->data[2], a value the device controls. A malicious, malfunctioning or counterfeit Touchwindow peripheral can stream non-zero bytes whose 2nd and 3rd bytes diffe
In the Linux kernel, the following vulnerability has been resolved: Input: mms114 - reject an oversized device packet size mms114_interrupt() reads a packet of touch data from the device into a fixed-size on-stack buffer struct mms114_touch touch[MMS114_MAX_TOUCH]; which holds MMS114_MAX_TOUCH (10) events of MMS114_EVENT_SIZE (8) bytes, i.e. 80 bytes. The length of the I2C read into it is taken verbatim from the device: packet_size = mms114_read_reg(data, MMS114_PACKET_SIZE); if (packet_size <= 0) goto out; ... error = __mms114_read_reg(data, MMS114_INFORMATION, packet_size, (u8 *)touch); packet_size is a single device registe
In the Linux kernel, the following vulnerability has been resolved: fuse: re-lock request before returning from fuse_ref_folio() fuse_ref_folio() unlocks the request but does not re-lock it before returning. fuse_chan_abort() can end the request and the async end callback (eg fuse_writepage_free()) can free the args while the subsequent copy chain logic after fuse_ref_folio() accesses them, leading to use-after-free issues. Fix this by locking the request in fuse_ref_folio() before returning.
In the Linux kernel, the following vulnerability has been resolved: Input: elan_i2c - validate firmware size before use Ensure that the firmware file is large enough to contain the expected number of pages and the signature (which resides at the end of the firmware blob) before accessing them to prevent potential out-of-bounds reads.
In the Linux kernel, the following vulnerability has been resolved: tty: serial: pch_uart: add check for dma_alloc_coherent() Add a check for dma_alloc_coherent() failure to prevent a potential NULL pointer dereference in dma_handle_rx(). Properly release DMA channels and the PCI device reference using a goto ladder if the allocation fails.
In the Linux kernel, the following vulnerability has been resolved: drm/amd/display: Validate payload length and link_index in dc_process_dmub_aux_transfer_async [Why&How] dc_process_dmub_aux_transfer_async() copies payload->length bytes into a 16-byte stack buffer (dpaux.data[16]) guarded only by an ASSERT(), which is a no-op in release builds. If a caller ever passes length > 16 this results in a stack buffer overflow via memcpy. Additionally, link_index is used to dereference dc->links[] without bounds checking against dc->link_count, risking an out-of-bounds access. Replace the ASSERT with a hard runtime check that returns false when
In the Linux kernel, the following vulnerability has been resolved: batman-adv: bla: fix report_work leak on backbone_gw purge batadv_bla_purge_backbone_gw() removes stale backbone gateway entries, but fails to properly handle their associated report_work: - If report_work is running, the purge must wait for it to finish before freeing the backbone_gw, otherwise the worker may access freed memory (e.g. bat_priv). - If report_work is pending, the purge must cancel it and release the reference held for that pending work item. The previous implementation called hlist_for_each_entry_safe() inside a spin_lock_bh() section, but cancel_wor
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: L2CAP: cancel pending_rx_work before taking conn->lock l2cap_conn_del() takes conn->lock and then calls cancel_work_sync() for pending_rx_work. process_pending_rx() takes the same mutex, so teardown can deadlock against the worker it is flushing. This issue was found by our static analysis tool and then manually reviewed against the current tree. The grounded PoC kept the l2cap_conn_ready() -> queue_work(..., &conn->pending_rx_work) submit path, the l2cap_conn_del() -> cancel_work_sync(&conn->pending_rx_work) teardown path, and the process_pending_rx() -> mute
In the Linux kernel, the following vulnerability has been resolved: i2c: stub: Reject I2C block transfers with invalid length The I2C_SMBUS_I2C_BLOCK_DATA case in stub_xfer() uses data->block[0] as the transfer length. The existing check only clamps it to avoid overrunning the chip->words[256] register array, but does not validate it against I2C_SMBUS_BLOCK_MAX (32), which is the limit of the union i2c_smbus_data.block buffer (34 bytes total). The driver is a development/test tool (CONFIG_I2C_STUB=m, not built by default) that must be loaded with a chip_addr= parameter. A local user with access to /dev/i2c-* can issue an I2C_SMBUS ioctl wi
In the Linux kernel, the following vulnerability has been resolved: net: team: fix NULL pointer dereference in team_xmit during mode change __team_change_mode() clears team->ops with memset() before restoring safe dummy handlers via team_adjust_ops(). A concurrent team_xmit() running under RCU on another CPU can read team->ops.transmit during this window and call a NULL function pointer, crashing the kernel. The race requires a mode change (CAP_NET_ADMIN) concurrent with transmit on the team device. BUG: kernel NULL pointer dereference, address: 0000000000000000 Oops: 0010 [#1] SMP KASAN NOPTI RIP: 0010:0x0 Call Trace: team_xmit (dr
In the Linux kernel, the following vulnerability has been resolved: xfs: fail recovery on a committed log item with no regions If the first op of a transaction is a bare transaction header (len == sizeof(struct xfs_trans_header)), xlog_recover_add_to_trans() adds an item but no region, leaving it on r_itemq with ri_cnt == 0 and ri_buf == NULL. The header can be split across op records, so later ops may still add regions; the item is only invalid if the transaction commits with none. The runtime commit path never emits such a transaction, so this only happens on a crafted log. It came from an AI-assisted code audit of the recovery parser.
In the Linux kernel, the following vulnerability has been resolved: Bluetooth: bnep: Fix UAF read of dev->name bnep_add_connection() needs to keep holding the bnep_session_sem while reading dev->name (just like bnep_get_connlist() does); otherwise the bnep_session() thread can concurrently free the net_device, which can for example be triggered by a concurrent bnep_del_connection(). (This UAF is fairly uninteresting from a security perspective; calling bnep_add_connection() requires passing a capable(CAP_NET_ADMIN) check. It also requires completely tearing down a netdev during a fairly tight race window.)
In the Linux kernel, the following vulnerability has been resolved: phonet/pep: disable BH around forwarded sk_receive_skb() The networking receive path is usually run from softirq context, but protocols that take the socket lock may have packets stored in the backlog and processed later from process context. In that case release_sock() -> __release_sock() drops the slock with spin_unlock_bh() and then calls sk->sk_backlog_rcv() with bottom halves enabled. Typical sk_backlog_rcv handlers process the socket whose backlog is being drained, so the BH state at entry is irrelevant for the slocks they touch. pep_do_rcv() is different: when the i
In the Linux kernel, the following vulnerability has been resolved: spi: qup: fix error pointer deref after DMA setup failure The driver falls back to PIO mode if DMA setup fails during probe. Make sure to the clear the DMA channel pointers on setup failure to avoid dereferencing an error pointer (or attempting to release a channel a second time) on later probe errors or driver unbind. This issue was flagged by Sashiko when reviewing a devres allocation conversion patch.
In the Linux kernel, the following vulnerability has been resolved: ALSA: asihpi: Fix potential OOB array access at reading cache find_control() to retrieve a cached info accesses the array with the given index blindly, which may lead to an OOB array access. Add a sanity check for avoiding it.
In the Linux kernel, the following vulnerability has been resolved: net: bcmgenet: keep RBUF EEE/PM disabled Setting RBUF_EEE_EN | RBUF_PM_EN in RBUF_ENERGY_CTRL breaks the RX path on GENET hardware once MAC EEE becomes active. RX traffic stops flowing while the link stays up and the usual descriptor/RX error counters remain quiet. In that state the MAC still accepts frames (rbuf_ovflow_cnt keeps climbing) but RBUF no longer forwards them to DMA, so rx_packets is no longer incremented at the netdev level. On some boards the corruption ends up as a paging fault in skb_release_data via bcmgenet_rx_poll on an LPI exit. Reproduced on Pi 4B (BC
Сопоставьте установленный стек и версии со свежими базами уязвимостей.