Уязвимости linux-aws-fips · Страница 127

net/sched: act_tunnel_key: Defer dst_release to RCU callback

In the Linux kernel, the following vulnerability has been resolved: net/sched: act_tunnel_key: Defer dst_release to RCU callback Fix a race-condition use-after-free in tunnel_key_release_params(). The function releases the metadata_dst of the old params synchronously via dst_release() while deferring the params struct free with kfree_rcu(). A concurrent tunnel_key_act() reader on the datapath may still hold the old params pointer (under rcu_read_lock_bh) and proceed to call dst_clone(&params->tcft_enc_metadata->dst) after the writer's dst_release has already pushed the dst's rcuref to RCUREF_DEAD. zdi-disclosures@trendmicro.com produced a

• Обновитесь до 5.15.0-1117.124+fips1

sctp: fix auth_hmacs array size in struct sctp_cookie

In the Linux kernel, the following vulnerability has been resolved: sctp: fix auth_hmacs array size in struct sctp_cookie The auth_hmacs array in struct sctp_cookie is supposed to store a complete SCTP_AUTH_HMAC_ALGO parameter, which consists of a struct sctp_paramhdr followed by N HMAC identifiers. However, the array size was calculated using an extra 2 bytes instead of sizeof(struct sctp_paramhdr), which is 4 bytes. When four HMAC identifiers are configured, the HMAC-ALGO parameter stored in the endpoint is larger than the auth_hmacs buffer in the cookie. As a result, sctp_association_init() copies beyond the end of auth_hmacs when init

• Обновитесь до 5.15.0-1117.124+fips1

usb: core: sysfs: add lock to bos_descriptors_read()

In the Linux kernel, the following vulnerability has been resolved: usb: core: sysfs: add lock to bos_descriptors_read() Add a lock to the function bos_descriptors_read(). This function accesses udev->bos, which could be simultaneously freed in usb_reset_and_verify_device(), a function that is commonly called in drivers all over the kernel.

wifi: at76c50x-usb: avoid length underflow in at76_guess_freq()

In the Linux kernel, the following vulnerability has been resolved: wifi: at76c50x-usb: avoid length underflow in at76_guess_freq() at76_guess_freq() checks only that the received frame is at least a bare 802.11 header (24 bytes) before subtracting the fixed management-body offset: len -= el_off; For both beacon and probe response frames, el_off is 36. If the frame is shorter than el_off, subtracting it causes the calculated IE length to wrap. The length is eventually passed to cfg80211_find_elem_match() as a very large unsigned value, so the element walk runs beyond the RX skb. This path is reached from at76_rx_tasklet() while scanning

• Обновитесь до 5.15.0-1117.124+fips1

usb: gadget: dummy_hcd: prevent fifo_req reuse during giveback

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: dummy_hcd: prevent fifo_req reuse during giveback dummy_hcd embeds a single shared usb_request (dum->fifo_req) that the "emulated single-request FIFO" fast-path in dummy_queue() reuses for small IN transfers: it copies the caller's request into it (req->req = *_req) and queues it, treating list_empty(&fifo_req.queue) as "the slot is free". The completion side (dummy_timer/transfer/nuke/dummy_dequeue) follows the standard pattern: list_del_init(&req->queue) unlinks the request, then the lock is dropped and usb_gadget_giveback_request() invokes req->complete().

• Обновитесь до 5.15.0-1117.124+fips1

usb: gadget: printer: fix infinite loop in printer_read()

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: printer: fix infinite loop in printer_read() printer_read() uses the same variable for the requested copy size and the number of bytes actually copied to user space. copy_to_user() returns the number of bytes not copied, so when it fails to copy anything, the computed copied length becomes zero. In that case len, buf, current_rx_bytes and current_rx_buf are left unchanged. If RX data is available and the user buffer remains unwritable, the read loop can repeat indefinitely. Track the copied length separately and return -EFAULT, or the number of bytes already

• Обновитесь до 5.15.0-1117.124+fips1

usb: gadget: f_ncm: validate datagram bounds in ncm_unwrap_ntb()

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: f_ncm: validate datagram bounds in ncm_unwrap_ntb() When unpacking host-supplied NTBs, ncm_unwrap_ntb() checks datagram length against frame_max but does not verify that the datagram fits within the declared block length. Additionally, when decoding multiple NTBs from a single socket buffer, subsequent block lengths are not checked against the actual remaining buffer data. With these checks missing, a malicious USB host can specify datagram offsets and lengths that point beyond the block, or supply secondary NTB headers declaring lengths larger than the buffer

• Обновитесь до 5.15.0-1117.124+fips1

usb: gadget: f_tcm: synchronize delayed set_alt with teardown

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: f_tcm: synchronize delayed set_alt with teardown The f_tcm set_alt() path defers endpoint setup to a work item and completes the delayed status response from process context. The delayed work uses f_tcm private state and may complete the setup request after disconnect or function teardown has already moved on. Cancel and drain the delayed set_alt work when the function is unbound or freed. For disable paths, which are reached under the composite device lock, use a small state machine and a non-sleeping cancellation path instead of cancel_work_sync(). If the wo

• Обновитесь до 5.15.0-1119.126+fips1

usb: gadget: uvc: clamp SEND_RESPONSE length to the response buffer

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: uvc: clamp SEND_RESPONSE length to the response buffer uvc_send_response() builds the UVC control response from a user-supplied struct uvc_request_data: req->length = min_t(unsigned int, uvc->event_length, data->length); ... memcpy(req->buf, data->data, req->length); req->length is clamped to uvc->event_length, which is taken from the host control request wLength (up to UVC_MAX_REQUEST_SIZE, 64), and to data->length, which comes from the UVCIOC_SEND_RESPONSE ioctl and is only checked for being negative. The source buffer data->data is only 60 bytes, so a

• Обновитесь до 5.15.0-1117.124+fips1

USB: serial: io_edgeport: cap received transmit credits

In the Linux kernel, the following vulnerability has been resolved: USB: serial: io_edgeport: cap received transmit credits The interrupt-status packet reports transmit credits returned by the device. edge_interrupt_callback() adds the 16-bit value to txCredits without checking maxTxCredits. edge_write() uses txCredits minus the software FIFO count as the amount of data that fits. Since the FIFO is allocated with maxTxCredits bytes, txCredits exceeding maxTxCredits can cause OOB write in ring buffer. Cap accumulated credits at maxTxCredits. Conforming devices should never hit the cap.

• Обновитесь до 5.15.0-1117.124+fips1

wifi: ath9k: hif_usb: don't dereference hif_dev after re-arming firmware request

In the Linux kernel, the following vulnerability has been resolved: wifi: ath9k: hif_usb: don't dereference hif_dev after re-arming firmware request ath9k_hif_request_firmware() re-arms an asynchronous firmware load via request_firmware_nowait(), passing hif_dev as the completion context, and then still dereferences hif_dev: dev_info(&hif_dev->udev->dev, "ath9k_htc: Firmware %s requested\n", hif_dev->fw_name); The re-armed callback ath9k_hif_usb_firmware_cb() runs on the "events" workqueue and, when the firmware is missing, walks the retry chain into ath9k_hif_usb_firmware_fail() -> complete_all(&hif_dev->fw_done). That releases the w

• Обновитесь до 5.15.0-1117.124+fips1

hwmon: (corsair-psu) Stop device IO before calling hid_hw_stop

In the Linux kernel, the following vulnerability has been resolved: hwmon: (corsair-psu) Stop device IO before calling hid_hw_stop hid_hw_stop() does not stop the device IO. This results in a race condition between hid_input_report() and the point immediately following the execution of hid_device_io_start() within corsairpsu_probe(). If the probe operation fails after "io start" has been initiated, this race condition will result in a uaf vulnerability [1]. CPU0 CPU1 ==== ==== corsairpsu_probe() hid_device_io_start() ... unlock driver_input_lock hid_hw_stop() kfree(hidraw) __hid_input_report() ... acquire driver_input_l

• Обновитесь до 5.15.0-1117.124+fips1

hwmon: (corsair-cpro) Stop device IO before calling hid_hw_stop

In the Linux kernel, the following vulnerability has been resolved: hwmon: (corsair-cpro) Stop device IO before calling hid_hw_stop Calling hid_hw_stop() does not stop the device IO. This results in a race condition between hid_input_report() and the point immediately following the execution of hid_device_io_start() within the driver probe function. If the probe operation fails after "io start" has been initiated, this race condition will result in a UAF vulnerability. Fix the problem by calling hid_device_io_stop() before calling hid_hw_stop().

• Обновитесь до 5.15.0-1117.124+fips1

watchdog: pretimeout: Fix UAF in watchdog_unregister_governor()

In the Linux kernel, the following vulnerability has been resolved: watchdog: pretimeout: Fix UAF in watchdog_unregister_governor() When a watchdog governor is unregistered, it updates existing watchdog devices that were using this governor by falling back to `default_gov`. If the governor being unregistered is currently set as `default_gov`, the `default_gov` is never cleared. This leads to 2 use-after-free issues: 1. New watchdog devices registered after this point will inherit the dangling `default_gov`. 2. Existing watchdog devices using the unregistered governor will have their `wdd->gov` reassigned to the dangling `default_gov

• Обновитесь до 5.15.0-1117.124+fips1

wifi: ath11k: fix potential buffer underflow in ath11k_hal_rx_msdu_list_get()

In the Linux kernel, the following vulnerability has been resolved: wifi: ath11k: fix potential buffer underflow in ath11k_hal_rx_msdu_list_get() When the first entry in msdu_details has a zero buffer address, the code accesses msdu_details[i - 1] with i == 0, causing a buffer underflow. Fix similarly to ath12k_wifi7_hal_rx_msdu_list_get() by adding a separate check for i == 0 before the main condition to prevent the out-of-bounds access. Found by Linux Verification Center (linuxtesting.org) with SVACE.

• Обновитесь до 5.15.0-1117.124+fips1

firewire: net: Fix fragmented datagram reassembly

In the Linux kernel, the following vulnerability has been resolved: firewire: net: Fix fragmented datagram reassembly fwnet_frag_new() keeps a sorted list of received fragments for a partial datagram. When a new fragment is adjacent to an existing fragment, the code checks whether the new fragment also closes the gap to the next or previous list entry. Those neighbor lookups currently assume that the current fragment always has a real next or previous fragment. At a list edge, the next or previous entry is the list head, not a struct fwnet_fragment_info. The gap checks also compare against the old edge of the current fragment instead of t

• Обновитесь до 5.15.0-1117.124+fips1

wifi: ath6kl: fix OOB read from firmware num_msg in TX complete handler

In the Linux kernel, the following vulnerability has been resolved: wifi: ath6kl: fix OOB read from firmware num_msg in TX complete handler The firmware-controlled num_msg field (u8, 0-255) drives the loop in ath6kl_wmi_tx_complete_event_rx() without validation against the buffer length. This allows out-of-bounds reads of up to 1020 bytes past the WMI event buffer when the firmware sends an inflated num_msg. Add a check that the buffer is large enough to hold the fixed struct and the num_msg variable-length entries.

• Обновитесь до 5.15.0-1117.124+fips1

wifi: ath6kl: fix OOB read from firmware IE lengths in connect event

In the Linux kernel, the following vulnerability has been resolved: wifi: ath6kl: fix OOB read from firmware IE lengths in connect event The firmware-controlled beacon_ie_len, assoc_req_len, and assoc_resp_len fields in ath6kl_wmi_connect_event_rx() are not validated against the buffer length. Their sum (up to 765) can exceed the actual WMI event data, causing out-of-bounds reads during IE parsing and state corruption of wmi->is_wmm_enabled. Add a check that the total IE length fits within the buffer.

• Обновитесь до 5.15.0-1117.124+fips1

wifi: carl9170: bound memcpy length in cmd callback to prevent OOB read

In the Linux kernel, the following vulnerability has been resolved: wifi: carl9170: bound memcpy length in cmd callback to prevent OOB read When the firmware sends a command response with a length mismatch, carl9170_cmd_callback() logs the mismatch and calls carl9170_restart() but then falls through to memcpy(ar->readbuf, buffer + 4, len - 4). Since len comes from the firmware and can exceed ar->readlen, this copies more data than the readbuf was allocated for. Bound the memcpy to min(len - 4, ar->readlen) so that the response is still completed -- avoiding repeated restarts from queued garbage -- while preventing an overread past the resp

• Обновитесь до 5.15.0-1117.124+fips1

wifi: carl9170: fix OOB read from off-by-two in TX status handler

In the Linux kernel, the following vulnerability has been resolved: wifi: carl9170: fix OOB read from off-by-two in TX status handler The bounds check in carl9170_tx_process_status() uses `i > ((cmd->hdr.len / 2) + 1)` which is off by two, allowing 2 extra iterations past valid _tx_status entries when the firmware- controlled hdr.ext exceeds hdr.len/2. Fix by using the correct comparison `i >= (cmd->hdr.len / 2)`.

• Обновитесь до 5.15.0-1117.124+fips1