Уязвимости linux-azure-fips · Страница 163

scsi: core: wake eh reliably when using scsi_schedule_eh

In the Linux kernel, the following vulnerability has been resolved: scsi: core: wake eh reliably when using scsi_schedule_eh Drivers which use the scsi_schedule_eh function to run the error handler currently risk the error handler thread never waking once all commands are timed out or inactive. There is no enforced memory order between setting the host into error recovery state and counting busy commands. This can result in a race with scsi_dec_host_busy where neither CPU sees both conditions of all commands inactive and the host error state to request waking the error handler. To fix this, run the scsi_schedule_eh's scsi_eh_wakeup from a

• Обновитесь до 6.8.0-1071.79+fips1

ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered

In the Linux kernel, the following vulnerability has been resolved: ata: sata_dwc_460ex: enable SATA interrupts only after IRQ handler is registered sata_dwc_enable_interrupts() is called before platform_get_irq() and ata_host_activate(), leaving the SATA controller's interrupt mask enabled without a registered handler. If a later step fails (irq request, phy init, etc.) or if the controller asserts an interrupt during probe, the irq line may fire with no handler, causing a spurious interrupt storm. Move sata_dwc_enable_interrupts() after ata_host_activate() so that interrupts are only unmasked once the handler is registered and the core

• Обновитесь до 6.8.0-1071.79+fips1

Bluetooth: mgmt: fix locking in unpair_device/disconnect_sync

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: mgmt: fix locking in unpair_device/disconnect_sync Dereferencing RCU-protected pointers outside critical sections is invalid and may lead to UAF. Take hdev->lock for hci_conn lookup and hci_abort_conn(). Don't use RCU to ensure the conn is fully initialized at this point.

• Обновитесь до 6.8.0-1071.79+fips1

Bluetooth: mgmt: hold reference for hci_conn in mgmt_pending_cmds

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: mgmt: hold reference for hci_conn in mgmt_pending_cmds Dereferencing RCU-protected pointers outside critical sections is invalid and may lead to UAF. Use of hci_conn in hci_sync callbacks also needs to hold refcount to avoid UAF. Take appropriate locks for hci_conn lookups, and take refcount for hci_conn pointers stored in mgmt_pending_cmd so that the pointer stays valid. When accessing conn->state, ensure hdev->lock is held to avoid data race.

• Обновитесь до 6.8.0-1071.79+fips1

Bluetooth: hci_qca: Clear memdump state on invalid dump size

In the Linux kernel, the following vulnerability has been resolved: Bluetooth: hci_qca: Clear memdump state on invalid dump size qca_controller_memdump() allocates qca->qca_memdump before processing the first dump packet. For a sequence-zero packet it then disables IBS, marks memdump collection active, and reads the advertised dump size. If the controller reports a zero dump size, the error path frees the local qca_memdump object and returns without clearing qca->qca_memdump or undoing the collection state. A later memdump work item initializes its local pointer from qca->qca_memdump and skips allocation when that pointer is non-NULL, so i

• Обновитесь до 6.8.0-1071.79+fips1

smb/client: handle overlapping allocated ranges in fallocate

In the Linux kernel, the following vulnerability has been resolved: smb/client: handle overlapping allocated ranges in fallocate smb3_simple_fallocate_range() can skip holes when an allocated range returned by the server starts before the current fallocate offset. The skipped hole is not zero-filled, but fallocate still returns success. A later write to that hole may therefore fail with ENOSPC. The function queries allocated ranges so that it can preserve existing contents and write zeroes only into holes. However, the server may return a range that starts before the current fallocate offset. For example, assume the fallocate request is [

• Обновитесь до 6.8.0-1071.79+fips1

bpf, sockmap: Reject unhashed UDP sockets on sockmap update

In the Linux kernel, the following vulnerability has been resolved: bpf, sockmap: Reject unhashed UDP sockets on sockmap update UDP sockets get SOCK_RCU_FREE set when (auto-)bound. This means sk_is_refcounted(unbound) = true, while sk_is_refcounted(bound) = false. Because sockmap accepts unbound UDP sockets, a BPF program can increment a socket's refcount via lookup. If the socket is subsequently bound, the transition from unbound to bound causes bpf_sk_release() to skip the decrement of the refcount, causing a memory leak. unreferenced object 0xffff88810bc2eb40 (size 1984): comm "test_progs", pid 2451, jiffies 4295320596 hex dump (fi

• Обновитесь до 6.8.0-1071.79+fips1

drm/xe/guc: Keep scheduler timeline name alive

In the Linux kernel, the following vulnerability has been resolved: drm/xe/guc: Keep scheduler timeline name alive The scheduler keeps a pointer to the timeline name, but q->name is freed with the exec queue while scheduler fences can still reference it. Store the name in struct xe_guc_exec_queue so it shares the scheduler's RCU-deferred lifetime. (cherry picked from commit 41075f0eb5dcbd3b065d15f15ef7bbe9315188e8)

drm/xe/guc: Hold device ref until queue teardown completes

In the Linux kernel, the following vulnerability has been resolved: drm/xe/guc: Hold device ref until queue teardown completes GuC exec queue destruction can run asynchronously. If the final device put happens from a destroy worker, drmm cleanup can end up draining the same workqueue and deadlock. Hold a drm_device reference for the queue lifetime and drop it after queue teardown completes. This keeps drmm cleanup from running while async destroy work is still pending. Move GuC destroy work to a module-lifetime Xe workqueue and flush it on PCI remove so hot-unbind/rebind still waits for pending destroy work. With queue-held device refs,

ksmbd: pin conn during async oplock break notification

In the Linux kernel, the following vulnerability has been resolved: ksmbd: pin conn during async oplock break notification smb2_oplock_break_noti() and smb2_lease_break_noti() store a ksmbd_conn pointer in an async ksmbd_work and then queue that work on ksmbd-io. The work only increments conn->r_count, which prevents teardown from passing the pending-request wait after the increment, but it does not pin the struct ksmbd_conn object. If connection teardown races with an oplock break notification, the last conn reference can be dropped before the queued worker finishes. The worker then uses the freed conn in ksmbd_conn_write() and ksmbd_co

• Обновитесь до 6.8.0-1071.79+fips1

net/sched: act_tunnel_key: Defer dst_release to RCU callback

In the Linux kernel, the following vulnerability has been resolved: net/sched: act_tunnel_key: Defer dst_release to RCU callback Fix a race-condition use-after-free in tunnel_key_release_params(). The function releases the metadata_dst of the old params synchronously via dst_release() while deferring the params struct free with kfree_rcu(). A concurrent tunnel_key_act() reader on the datapath may still hold the old params pointer (under rcu_read_lock_bh) and proceed to call dst_clone(&params->tcft_enc_metadata->dst) after the writer's dst_release has already pushed the dst's rcuref to RCUREF_DEAD. zdi-disclosures@trendmicro.com produced a

• Обновитесь до 6.8.0-1071.79+fips1

sctp: fix auth_hmacs array size in struct sctp_cookie

In the Linux kernel, the following vulnerability has been resolved: sctp: fix auth_hmacs array size in struct sctp_cookie The auth_hmacs array in struct sctp_cookie is supposed to store a complete SCTP_AUTH_HMAC_ALGO parameter, which consists of a struct sctp_paramhdr followed by N HMAC identifiers. However, the array size was calculated using an extra 2 bytes instead of sizeof(struct sctp_paramhdr), which is 4 bytes. When four HMAC identifiers are configured, the HMAC-ALGO parameter stored in the endpoint is larger than the auth_hmacs buffer in the cookie. As a result, sctp_association_init() copies beyond the end of auth_hmacs when init

• Обновитесь до 6.8.0-1071.79+fips1

usb: core: sysfs: add lock to bos_descriptors_read()

In the Linux kernel, the following vulnerability has been resolved: usb: core: sysfs: add lock to bos_descriptors_read() Add a lock to the function bos_descriptors_read(). This function accesses udev->bos, which could be simultaneously freed in usb_reset_and_verify_device(), a function that is commonly called in drivers all over the kernel.

wifi: at76c50x-usb: avoid length underflow in at76_guess_freq()

In the Linux kernel, the following vulnerability has been resolved: wifi: at76c50x-usb: avoid length underflow in at76_guess_freq() at76_guess_freq() checks only that the received frame is at least a bare 802.11 header (24 bytes) before subtracting the fixed management-body offset: len -= el_off; For both beacon and probe response frames, el_off is 36. If the frame is shorter than el_off, subtracting it causes the calculated IE length to wrap. The length is eventually passed to cfg80211_find_elem_match() as a very large unsigned value, so the element walk runs beyond the RX skb. This path is reached from at76_rx_tasklet() while scanning

• Обновитесь до 6.8.0-1071.79+fips1

usb: core: port: Deattach Type-C connector on component unbind

In the Linux kernel, the following vulnerability has been resolved: usb: core: port: Deattach Type-C connector on component unbind connector_unbind() is the mirror of connector_bind(), but it is missing the symmetric call to typec_deattach() that connector_bind() makes via: if (port_dev->child) typec_attach(port_dev->connector, &port_dev->child->dev); When a Thunderbolt dock is unplugged, two teardown paths race: 1. The component framework calls connector_unbind() first, which sets port_dev->connector = NULL without calling typec_deattach(). This leaves port->usb2_dev/port->usb3_dev in struct typec_port pointing at

• Обновитесь до 6.8.0-1071.79+fips1

usb: musb: omap2430: Do not put borrowed of_node in probe

In the Linux kernel, the following vulnerability has been resolved: usb: musb: omap2430: Do not put borrowed of_node in probe omap2430_probe() stores pdev->dev.of_node in a local np variable. This is a borrowed pointer and the probe function does not take a reference to it. The success and error paths nevertheless call of_node_put(np). This drops a reference that is owned by the platform device, and can leave pdev->dev.of_node with an unbalanced reference count. Do not put the borrowed platform device node from omap2430_probe(). References taken for the child MUSB device are handled by the device core, and the ctrl-module phandle referenc

• Обновитесь до 6.8.0-1071.79+fips1

usb: gadget: dummy_hcd: prevent fifo_req reuse during giveback

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: dummy_hcd: prevent fifo_req reuse during giveback dummy_hcd embeds a single shared usb_request (dum->fifo_req) that the "emulated single-request FIFO" fast-path in dummy_queue() reuses for small IN transfers: it copies the caller's request into it (req->req = *_req) and queues it, treating list_empty(&fifo_req.queue) as "the slot is free". The completion side (dummy_timer/transfer/nuke/dummy_dequeue) follows the standard pattern: list_del_init(&req->queue) unlinks the request, then the lock is dropped and usb_gadget_giveback_request() invokes req->complete().

• Обновитесь до 6.8.0-1071.79+fips1

usb: gadget: printer: fix infinite loop in printer_read()

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: printer: fix infinite loop in printer_read() printer_read() uses the same variable for the requested copy size and the number of bytes actually copied to user space. copy_to_user() returns the number of bytes not copied, so when it fails to copy anything, the computed copied length becomes zero. In that case len, buf, current_rx_bytes and current_rx_buf are left unchanged. If RX data is available and the user buffer remains unwritable, the read loop can repeat indefinitely. Track the copied length separately and return -EFAULT, or the number of bytes already

• Обновитесь до 6.8.0-1071.79+fips1

usb: gadget: f_ncm: validate datagram bounds in ncm_unwrap_ntb()

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: f_ncm: validate datagram bounds in ncm_unwrap_ntb() When unpacking host-supplied NTBs, ncm_unwrap_ntb() checks datagram length against frame_max but does not verify that the datagram fits within the declared block length. Additionally, when decoding multiple NTBs from a single socket buffer, subsequent block lengths are not checked against the actual remaining buffer data. With these checks missing, a malicious USB host can specify datagram offsets and lengths that point beyond the block, or supply secondary NTB headers declaring lengths larger than the buffer

• Обновитесь до 6.8.0-1071.79+fips1

usb: gadget: f_tcm: synchronize delayed set_alt with teardown

In the Linux kernel, the following vulnerability has been resolved: usb: gadget: f_tcm: synchronize delayed set_alt with teardown The f_tcm set_alt() path defers endpoint setup to a work item and completes the delayed status response from process context. The delayed work uses f_tcm private state and may complete the setup request after disconnect or function teardown has already moved on. Cancel and drain the delayed set_alt work when the function is unbound or freed. For disable paths, which are reached under the composite device lock, use a small state machine and a non-sleeping cancellation path instead of cancel_work_sync(). If the wo