PatchFirst · Свежие уязвимости
За последние 30 дней в linux-realtime опубликовано уязвимостей: 632; в каталоге KEV: 0.
Уязвимостей: 10259
In the Linux kernel, the following vulnerability has been resolved: dm-verity: make error counter atomic The error counter "v->corrupted_errs" was not atomic, thus it could be subject to race conditions. The call to dm_audit_log_target("max-corrupted-errors") may be skipped due to the races.
In the Linux kernel, the following vulnerability has been resolved: accel/ivpu: Reject firmware log with size smaller than header fw_log_from_bo() validates the tracing buffer header_size and that the log fits within the BO, but never checks that log->size is at least log->header_size. fw_log_print_buffer() then computes: u32 data_size = log->size - log->header_size; which underflows to a near-U32_MAX value when firmware reports a log whose size is smaller than its header. That huge data_size defeats the log_start/log_end bounds clamps added by commit dd1311bcf0e6 ("accel/ivpu: Add bounds checks for firmware log indices"), so fw_log_pri
In the Linux kernel, the following vulnerability has been resolved: scsi: hpsa: Fix DMA mapping leak on IOACCEL2 reset path If phys_disk->in_reset is set, the function returns directly without undoing the resources acquired for the command. Add the missing error cleanup by unmapping the IOACCEL2 SG chain block when needed, unmapping the SCSI command, and dropping the outstanding IOACCEL command count before returning.
In the Linux kernel, the following vulnerability has been resolved: scsi: lpfc: Fix memory leak in lpfc_sli4_driver_resource_setup() The memory allocated for mboxq using mempool_alloc() is not freed in some of the early exit error paths. Fix that by moving the mempool_free() call to an earlier point after last use.
In the Linux kernel, the following vulnerability has been resolved: scsi: xen: scsiback: Free the command tag on the TMR submit-failure path scsiback_device_action() obtains a command tag in scsiback_get_pend_req() and submits a task-management request with target_submit_tmr(). When target_submit_tmr() fails it returns < 0 and scsiback jumps to the err: label, which sends a response but frees nothing, leaking the tag. Impact: a pvSCSI guest can leak the command tags of a LUN's session, stopping the LUN, by issuing VSCSIIF_ACT_SCSI_ABORT or RESET requests whenever target_submit_tmr() fails. transport_generic_free_cmd() cannot be used here.
In the Linux kernel, the following vulnerability has been resolved: scsi: xen: scsiback: Free unsubmitted command instead of double-putting it scsiback_get_pend_req() obtains a command tag and returns a vscsibk_pend whose embedded se_cmd has only been memset to 0, so its cmd_kref is 0; the se_cmd is initialised (kref_init() via target_init_cmd()) only later, in scsiback_cmd_exec(), on the successful VSCSIIF_ACT_SCSI_CDB path. The two error paths in scsiback_do_cmd_fn() taken before the command is submitted -- a failed scsiback_gnttab_data_map() and an unknown ring_req.act -- call transport_generic_free_cmd(&pending_req->se_cmd, 0), which kr
In the Linux kernel, the following vulnerability has been resolved: scsi: target: Bound PR-OUT TransportID parsing to the received buffer core_scsi3_decode_spec_i_port() and core_scsi3_emulate_register_and_move() hand the raw PERSISTENT RESERVE OUT parameter buffer to target_parse_pr_out_transport_id() without telling it how many bytes are valid. For an iSCSI TransportID (FORMAT CODE 01b), iscsi_parse_pr_out_transport_id() locates the ",i,0x" ISID separator with an unbounded strstr() (and on the error path prints the name with a further unbounded "%s"). An initiator can submit a TransportID whose iSCSI name contains neither a ",i,0x" subs
In the Linux kernel, the following vulnerability has been resolved: scsi: target: core: Fix iSCSI ISID use-after-free in REGISTER AND MOVE core_scsi3_emulate_pro_register_and_move() maps the PERSISTENT RESERVE OUT parameter list with transport_kmap_data_sg() and parses the destination TransportID with target_parse_pr_out_transport_id(). For an iSCSI TransportID (FORMAT CODE 01b), iscsi_parse_pr_out_transport_id() returns the ISID in iport_ptr as a raw pointer into that mapped buffer. The function then unmaps the buffer with transport_kunmap_data_sg() before dereferencing iport_ptr in strcmp(), __core_scsi3_locate_pr_reg() and core_scsi3_al
In the Linux kernel, the following vulnerability has been resolved: scsi: elx: efct: Fix refcount leak in efct_hw_io_abort() When efct_hw_reqtag_alloc() fails in efct_hw_io_abort(), the error path returns -ENOSPC without releasing the reference obtained via kref_get_unless_zero() earlier in the function. All other error paths correctly drop the reference. This causes a permanent reference leak on the io_to_abort object. Additionally, the abort_in_progress flag is left set to true on this path, which means future abort attempts for the same I/O will immediately return -EINPROGRESS even though the abort was never submitted, effectively block
In the Linux kernel, the following vulnerability has been resolved: scsi: elx: efct: Fix I/O leak on unsupported additional CDB efct_dispatch_fcp_cmd() allocates an efct_io before dispatching an unsolicited FCP command. If the command has an unsupported additional CDB, the function returns -EIO before handing the IO to the SCSI layer. Free the allocated IO before returning from this error path.
In the Linux kernel, the following vulnerability has been resolved: Input: ims-pcu - fix use-after-free and double-free in disconnect ims_pcu_disconnect() only intended to perform cleanup when the primary (control) interface is unbound. However, it currently relies on the interface class to distinguish between control and data interfaces. A malicious device could present a data interface with the same class as the control interface, leading to premature cleanup and potential use-after-free or double-free. Switch to verifying that the interface being disconnected is indeed the control interface.
In the Linux kernel, the following vulnerability has been resolved: Input: ims-pcu - validate control endpoint type The driver currently assumes that the first endpoint of the control interface is an interrupt IN endpoint without verifying it. A malicious device could provide a different endpoint type, which would then be passed to usb_fill_int_urb(), potentially leading to kernel warnings or undefined behavior. Verify that the control endpoint is an interrupt IN endpoint.
In the Linux kernel, the following vulnerability has been resolved: Input: ims-pcu - fix firmware leak in async update The firmware object was not being released if validation failed. Use __free(firmware) to ensure the firmware is always released.
In the Linux kernel, the following vulnerability has been resolved: Input: ims-pcu - fix out-of-bounds read in ims_pcu_irq() debug logging The debug logging in ims_pcu_irq() unconditionally prints data from pcu->urb_in_buf. However, if the interrupt fired for pcu->urb_ctrl, the actual data resides in pcu->urb_ctrl_buf. If urb->actual_length for the control URB exceeds pcu->max_in_size, this leads to an out-of-bounds read. Fix this by printing from the correct buffer associated with the URB.
In the Linux kernel, the following vulnerability has been resolved: Input: ims-pcu - fix race condition in reset_device sysfs callback The ims_pcu_reset_device() sysfs callback calls ims_pcu_execute_command() without acquiring pcu->cmd_mutex. This can lead to data races and corruption of the shared command buffer if triggered concurrently with other commands. Acquire pcu->cmd_mutex before calling ims_pcu_execute_command().
In the Linux kernel, the following vulnerability has been resolved: Input: ims-pcu - fix type confusion in CDC union descriptor parsing The driver currently trusts the bMasterInterface0 from the CDC union descriptor without verifying that it matches the interface being probed. This could lead to the driver overwriting the private data of another interface. Validate that the control interface found in the descriptor is indeed the one we are probing.
In the Linux kernel, the following vulnerability has been resolved: mmc: vub300: fix use-after-free on probe failure The vub300 driver lifetime-manages its controller state using vub300->kref, with vub300_delete() freeing the mmc host when the last reference is dropped. The probe error path after the inactivity timer has been armed still bypasses that lifetime rule, however, and falls through to mmc_free_host() directly if mmc_add_host() fails. The race window is between arming the inactivity timer and reaching the probe error unwind after mmc_add_host() fails: probe thread timer/workqueue ------------
In the Linux kernel, the following vulnerability has been resolved: net/mlx5e: macsec: fix use-after-free of metadata_dst on RX SC delete When an offloaded MACsec RX SC is deleted, macsec_del_rxsc_ctx() freed the per-SC metadata_dst with metadata_dst_free(), which kfree()s the object unconditionally and ignores the dst reference count. The RX datapath in mlx5e_macsec_offload_handle_rx_skb() looks up the SC under rcu_read_lock() via xa_load(), takes a reference with dst_hold() and attaches the dst to the skb with skb_dst_set(). A reader that already obtained the rx_sc pointer can race with the delete path and operate on freed memory. Fix th
In the Linux kernel, the following vulnerability has been resolved: tracing/user_events: Fix use-after-free in user_event_mm_dup() user_event_mm_dup() walks the parent mm's enabler list locklessly under rcu_read_lock() during fork() (from copy_process()); it does not take event_mutex: rcu_read_lock(); list_for_each_entry_rcu(enabler, &old_mm->enablers, mm_enablers_link) enabler->event = user_event_get(orig->event); user_event_enabler_destroy() removes an enabler from that list with list_del_rcu() and then, without waiting for a grace period, drops the enabler's user_event reference with user_event_put() and frees the enabler with kfre
In the Linux kernel, the following vulnerability has been resolved: wifi: libertas_tf: fix use-after-free in lbtf_free_adapter() lbtf_free_adapter() calls timer_delete(&priv->command_timer), which does not wait for a running command_timer_fn() callback. lbtf_free_adapter() runs on the teardown path right before ieee80211_free_hw() frees priv, both in lbtf_remove_card() and in the probe error path. command_timer is armed by mod_timer() in lbtf_cmd() whenever a firmware command is sent. command_timer_fn() dereferences priv. If a command times out as the device is removed, command_timer_fn() runs concurrently with teardown and dereferences pri
Сопоставьте установленный стек и версии со свежими базами уязвимостей.