Высокий · CVSS 8.8EPSS 0,23%Нет опубликованного исправления
Out-of-bounds write in the USB Bluetooth HCI transport class when a controller-to-host HCI packet exceeds the bulk endpoint maximum packet size
The Bluetooth HCI USB transport class of the new USB device stack, subsys/usb/device_next/class/bt_hci.c, copies every controller-to-host HCI packet into a USB transfer buffer before enqueuing it on an endpoint. bt_hci_tx_sync_in() allocated that buffer from bt_hci_ep_pool, a fixed pool whose slots are only USBD_MAX_BULK_MPS bytes (64 on full-speed-only builds), and then performed net_buf_add_mem(buf, bt_buf->data, bt_buf->len) with no length check. HCI event and ACL buffers are sized by CONFIG_BT_BUF_EVT_RX_SIZE and CONFIG_BT_BUF_ACL_RX_SIZE and can be far larger, so the copy runs past the end of the 64-byte slot into the adjacent slots and
Средний · CVSS 6.5EPSS 0,12%Нет опубликованного исправления
DNS resolver reuses a single UDP source port for all queries, easing off-path answer spoofing
The DNS stub resolver in subsys/net/lib/dns/resolve.c binds one UDP socket per configured server when the resolver context is initialised (dns_resolve_init_locked() -> register_dispatcher() -> dns_dispatcher_register()), with the local port left at 0 so the stack picks an ephemeral port exactly once. dns_write() then sends every subsequent query from that same socket without re-binding, so the source port is constant for the lifetime of the resolver context while only the 16-bit transaction identifier (ctx->queries[i].id, drawn with sys_rand16_get()) varies per query. RFC 5452 section 9.2 requires both to vary; with a fixed port, an off-path
Средний · CVSS 5.6EPSS 0,17%Нет опубликованного исправления
Predictable and reused DHCPv4 transaction identifier allows spoofed DHCP replies to reconfigure gateway and DNS
The DHCPv4 client in subsys/net/lib/dhcpv4/dhcpv4.c maintained its transaction identifier (iface->config.dhcpv4.xid) as a counter rather than as a per-transaction random value. It was seeded once with sys_rand32_get() in dhcpv4_start_internal(), incremented by one in dhcpv4_send_discover() and dhcpv4_send_decline(), and never changed by dhcpv4_send_request() — so every RENEWING and REBINDING exchange reused, unchanged, the identifier that had already appeared on the wire in the broadcast DHCPDISCOVER at boot, and where the identifier did move it moved predictably by one. RFC 2131 4.1 requires a single identifier per transaction, chosen so tha
Высокий · CVSS 7.8EPSS 0,1%Нет опубликованного исправления
Stale TLB entries after demand-paging page-out let arm64 user threads access reused physical frames
The arm64 MMU backend invalidates a single virtual address from the TLB with invalidate_tlb_page() in arch/arm64/core/mmu.c, which issued TLBI VAE1{IS} with an operand of virt >> 12. That operand encodes the ASID in bits [63:48], so the invalidation only ever matched ASID 0 (the kernel page tables) and global entries. Memory domains, however, are allocated ASIDs starting at 1 in arch_mem_domain_init(), and every domain-private leaf created by private_map() is mapped with MT_NG, i.e. non-global. A domain's cached translation therefore survived the invalidation.
All callers of invalidate_tlb_page() are demand-paging paths. When the eviction al
Out-of-bounds write in the ADXL345 sensor driver RTIO streaming FIFO read path
The RTIO streaming completion callback adxl345_process_fifo_samples_cb() in drivers/sensor/adi/adxl345/adxl345_stream.c clamps the amount of FIFO data it will report (read_len = MIN(fifo_bytes, buf_avail)) to the space actually returned by rtio_sqe_rx_buf(), but then queues one 6-byte bus read per hardware FIFO entry at consecutive offsets from read_buf, bounded by the device-reported entry count rather than by the clamp. When the allocated buffer is smaller than a full batch, the driver writes up to 186 bytes past the end of the allocation; a companion defect left data->fifo_total_bytes un-reset at batch start, so an aborted or errored chain
Высокий · CVSS 8.2EPSS 0,17%Нет опубликованного исправления
WireGuard peer endpoint learned from unauthenticated transport-data messages allows off-path tunnel hijack in Zephyr
The WireGuard VPN service in subsys/net/lib/wireguard/wg.c updated the peer endpoint from a message it could not authenticate. In handle_transport_data(), when the 32-bit receiver index of an incoming transport-data message matched no session, the code both scheduled a new handshake and copied the datagram's source address into peer->endpoint with memcpy(&peer->endpoint, peer_addr, sizeof(peer->endpoint)). Because the receiver index is unknown, there is no key with which such a message could be verified, so the address written into peer->endpoint is entirely attacker-supplied. Every other endpoint update in the implementation happens only aft
Zephyr's OpenThread integration defined CONFIG_OPENTHREAD_JOINER_PSKD with default "J01NME" in modules/openthread/Kconfig.thread (previously subsys/net/l2/openthread/Kconfig, then subsys/net/l2/openthread/Kconfig.thread). J01NME is the example Joining Device Credential used throughout the public OpenThread and Thread commissioning documentation, including Zephyr's own samples/net/sockets/echo_client/README.rst, so it is not a secret. A firmware image built with CONFIG_OPENTHREAD_JOINER_AUTOSTART=y that never overrode the PSKd therefore shipped with a publicly known joining credential compiled in, with no build-time or run-time warning.
The P
Высокий · CVSS 7.1EPSS 0,28%Нет опубликованного исправления
Out-of-bounds access in Bluetooth ISO receive (`bt_iso_recv`) due to missing SDU-header length validation
bt_iso_recv() in subsys/bluetooth/host/iso.c pulled the ISO SDU header (4 bytes) or, when the timestamp flag is set, the timestamped SDU header (8 bytes) from the inbound HCI ISO Data buffer via net_buf_pull_mem() without first checking buf->len. The upstream hci_iso() handler enforces buf->len == the controller-declared ISO Data_Load length, so a malicious or buggy controller / adjacent BLE peer on an established CIS/BIS can present a first-fragment (BT_ISO_START) or single (BT_ISO_SINGLE) PDU shorter than the SDU header. Because net_buf_simple_pull_mem only guards length with __ASSERT_NO_MSG (compiled out when CONFIG_ASSERT is disabled, the
Высокий · CVSS 7.1EPSS 0,3%Нет опубликованного исправления
Out-of-bounds read in Bluetooth Classic SDP attribute parsing (`bt_sdp_parse_attribute`)
bt_sdp_parse_attribute() in subsys/bluetooth/host/classic/sdp.c validated only that the SDP record buffer held the type-marker byte plus the 2-byte attribute ID (a check of buf->len < 3) but then read a fourth byte, the data-element descriptor (type), via net_buf_simple_pull_u8(). Because net_buf_simple_pull_u8() dereferences buf->data[0] before its only bounds guard (an __ASSERT_NO_MSG that compiles out when CONFIG_ASSERT is disabled, the production default), a record of exactly three bytes (0x09 followed by a 2-byte attribute ID) causes a one-byte read past the end of the logical buffer. The parser is reachable from inbound, remote-controll
Средний · CVSS 4.9EPSS 0,16%Нет опубликованного исправления
Out-of-bounds read in Zephyr ext2 directory entry traversal from a crafted filesystem image
The Zephyr ext2 filesystem driver (subsys/fs/ext2) trusted the on-disk directory entry fields de_rec_len and de_name_len when walking a directory block. ext2_fetch_direntry() guarded only with de_name_len > EXT2_MAX_FILE_NAME, but de_name_len is a uint8_t and EXT2_MAX_FILE_NAME is 255, so the check is always false; the function then memcpy'd up to 255 name bytes and the lookup/readdir paths advanced traversal by an unvalidated de_rec_len. Each directory block is read into a block_size-sized slab buffer, and block_off can be driven near the block end by preceding entries' rec_len, so the 8-byte header read and the subsequent name memcpy can re
The Zephyr Project Manager WordPress plugin before 3.2.55 does not have any authorisation as well as CSRF in all its AJAX actions, allowing unauthenticated users to call them either directly or via CSRF attacks. Furthermore, due to the lack of sanitisation and escaping, it could also allow them to perform Stored Cross-Site Scripting attacks against logged in admins.
Высокий · CVSS 8.2EPSS 0,48%Нет опубликованного исправления
The RNDIS USB device class includes a buffer overflow vulnerability
The RNDIS USB device class includes a buffer overflow vulnerability. Zephyr versions >= v2.6.0 contain Heap-based Buffer Overflow (CWE-122). For more information, see https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-hvfp-w4h8-gxvj
Высокий · CVSS 8.2EPSS 0,74%Нет опубликованного исправления
Buffer overflow in usb device class
Buffer overflow in usb device class. Zephyr versions >= v2.6.0 contain Heap-based Buffer Overflow (CWE-122). For more information, see https://github.com/zephyrproject-rtos/zephyr/security/advisories/GHSA-fm6v-8625-99jf